MFJ MFJ-1438 User Manual

12 MONTH LIMITED WARRANTY

MFJ Enterprises, Inc. Warrants to the original owner of this product, if manufactured by MFJ Enterprises, Inc. and purchased from an authorized dealer or directly from MFJ Enterprises, Inc. to be free from defects in material and workmanship for a period of 12 months from date of purchase provided the following terms of this warranty are satisfied.

1. The purchaser must retain the dated proof-of-purchase (bill of sale, canceled check, credit card or money order receipt, etc.) describing the product to establish the validity of the warranty claim and submit the original or machine reproduction of such proof-of-purchase to MFJ Enterprises, Inc. at the time of warranty service. MFJ Enterprises, Inc. shall have the discretion to deny warranty without dated proof-of-purchase. Any evidence of alteration, erasure, or forgery shall be cause to void any and all warranty terms immediately.

2. MFJ Enterprises, Inc. agrees to repair or replace at MFJ’s option without charge to the original owner any defective product under warranty, provided the product is returned postage prepaid to MFJ Enterprises, Inc. with a personal check, cashiers check, or money order for $7.00 covering postage and handling.

3. MFJ Enterprises, Inc. will supply replacement parts free of charge for any MFJ product under warranty upon request. A dated proof-of-purchase and a $5.00 personal check, cashiers check, or money order must be provided to cover postage and handling.

4. This warranty is NOT void for owners who attempt to repair defective units. Technical consultation is available by calling (662) 323-5869.

5. This warranty does not apply to kits sold by or manufactured by MFJ Enterprises, Inc.

6. Wired and tested PC board products are covered by this warranty provided only the wired and tested PC board product is returned. Wired and tested PC boards installed in the owner’s cabinet or connected to switches, jacks, or cables, etc. sent to MFJ Enterprises, Inc. will be returned at the owner’s expense unrepaired.

7. Under no circumstances is MFJ Enterprises, Inc. liable for consequential damages to person or property by the use of any MFJ products.

8. Out-of-warranty Service: MFJ Enterprises, Inc. will repair any out-of-warranty product provided the unit is shipped prepaid. All repaired units will be shipped COD to the owner. Repair charges will be added to the COD fee unless other arrangements are made.

9. This warranty is given in lieu of any other warranty expressed or implied.

10. MFJ Enterprises, Inc. reserves the right to make changes or improvements in design or manufacture without incurring any obligation to install such changes upon any of the products previously manufactured.

11. All MFJ products to be serviced in-warranty or out-of-warranty should be addressed to MFJ Enterprises, Inc., 300 Industrial Park Road, Starkville, Mississippi 39759, USA and must be accompanied by a letter describing the problem in detail along with a copy of your dated proof-ofpurchase.

12. This warranty gives you specific rights, and you may also have other rights, which vary from state to state.

MFJ-1438

Quad-Band Mobile Antenna

Instruction Manual

Thank you for purchasing the MFJ-1438, Quad-Band Mobile Antenna. Please read this instruction manual completely and thoroughly before using the MFJ-1438. This antenna is ideal for use with the Yaesu FT-8900R quad-band mobile transceiver and other triband (6M/2M/70cm) transceivers. Other HF mobile transceivers might require a duplexer or triplexer.

Specifications:

• Bands: 10-Meter, 6-Meter, 2-Meter, and 440 MHz

• Maximum Power

10-Meter – 200W SSB / 60W FM 6-Meter – 200W SSB / 100W FM 2-Meter/70cm – 100W FM

• SWR

10-Meter – 1.6:1 or less 6M-70cm – 1.5:1 or less

• Gain and Phasing

10-Meter – 0 Gain, ¼ Wave 6M – 0 Gain, ¼ Wave 2M – 2.15 dBi Gain, ½ Wave 70cm – 5.5 dBi Gain, 5/8 Wave X 2

• Connector: PL-259

• Fold-over feature with threaded collar.

Installation Instructions:

• Select a suitable mount for the MFJ-1438. The MFJ-345S and

MFJ-348S trunklip mounts or the MFJ-336S Goliath triple magmount are recommended.

• Be sure the mount has a good connection to ground (this is

most important).

• Screw the MFJ-1438 onto your mount.

• For added support, it is suggested that you guy the top of the

antenna.

Tuning

• The bandwidth on the 10-Meter and 6-Meter bands is very narrow.

Tuning may be required depending on the part of the band you want to operate.

• To adjust the frequency there are two stubs: the top stub is for the

10-Meter Band and the side stub is for the 6-Meter band.

• For operating at the top of the band, it may be necessary to cut one

or both stubs.

• Use the hex key supplied to loosen the setscrew, and adjust the

stub length.

• Tighten the setscrew securely after tuning is complete.

Notes:

• Tuning this antenna for the 10-Meter band will affect the tuning on

the 6-Meter band. Tuning this antenna for the 6-Meter band will affect the tuning on the 10-Meter band. After tuning for one band is complete, go back and recheck the tuning on the other band.

• Be careful if you have to cut the stubs to tune this antenna, it is

recommended not to exceed increments of 0.1 inches.

• This antenna is very sensitive. You may find that switching

vehicles adversely affects the operation. It may be necessary to retune the antenna when switching vehicles.

Fold-Over Feature

• Unscrew the threaded collar at the base of the antenna.

• Lift the antenna up until the hinge is revealed.

• Gently fold the antenna over in a suitable position for temporary

storage.

Warning:

• Do not touch the antenna while in use.

• Place the antenna in a location away from people. Serious RF

burns may occur if a person comes in contact with the antenna.

• NEVER INSTALL AN ANTENNA IN A LOCATION

WHERE CONTACT WITH POWER LINES IS POSSIBLE. DEATH OR SERIOUS INJURY MAY OCCUR.