Meyer HOTSHOT 38191 Owner's Manual
HOTSHOT
HOTSHOT
HOTSHOTHOTSHOT
COMMERCIAL DROP SPREADER
MODEL #38191
38191
3819138191
A
E
R
P
S
P
O
R
D
R
E
D
OWNER’S MANUAL
ASSEMBLY INSTRUCTIONS
Handle Brace
Leg
1/4-20 X 1/2”
Hex Bolt
1.
Remove spreader and components from carton. Place
Leg Bracket
Hopper on it’s front panel, insert two (2) 1/4-20 X 1/2” Hex
Head Bolts through the Leg Bracket (note hole location),
flattened end of Handle Brace, and holes in Hopper as
shown. Install Lockwashers and Nuts. Secure Leg to Bracket
(Leg can be located in 2 positions to best fit operator) using
(2) 1/4-20 X 1/2” Hex Head Bolts, Lockwashers and Nuts.
Repeat on opposite side.
Nut
Nut
Lock
Washer
3/16 X 2”
Cotter Pin
Drive Wheel
2.
Slide Wheels onto each end of Axle with
the longer portion of the Wheel facing the
Hopper. Secure Wheels with 3/16 dia. x 2”
Cotter Pins.
Lock
Washer
1/4-20 X 1 1/2”
Hex Bolt
Handle Lever
Assembly
Handle Grip
1/4-20 X 1 1/2”
Hex Bolt
3.
Install Control Tube between the
Lock
Washer
Control Tube Braces and secure with (2)
1/4-20 X 1 1/2” Hex Bolts, Lockwashers,
and nuts.
1/4” D.
Clevis
Cotter Pin
Control Tube
Brace
5.
Slide the ends of the Control Tube Braces over the Studs on
Cotter Pin
Hopper Handle
the Shutoff Bar Brackets, secure with Cotter Pins. Attached
opposite end of Control Tube to the Handle Lever using 1/4 dia.
Clevis and Cotter Pin. Make sure Handle Lever operates freely.
Tighten all Nuts left loose in step #1. Install Hopper Handle on
front of spreader using two 1/4-20 x 1/2” Hex Bolts and Locknuts.
Nut
4.
Stand spreader upright on Wheels. Attach
1/4” D. Clevis
Cotter
Upper Handle assembly to Handle Brace
(make sure Handle is positioned as shown)
using (4) 1/4-20 X 1 1/2” Hex Bolts, (4) Lock
Washers, and (4) Nuts. Tighten securely.
Install Handle Grips onto Upper Handle.
Slide Handle Lever assembly between
Handle Brackets and secure with 1/4 dia,
Clevis and Cotter Pin. Make sure Lever
pivots freely.
6.
To check spreader for completed shutoff,
pull the Handle Lever back to the “OFF”
position. Turn spreader over to see if the
Shutoff Bar completely covers the holes in
the bottom of the Hopper. If not, stand the
spreader upright on Wheels push the Handle
Lever forward to the “ON” position. Loosen
the Bolts in the Hopper holding the Handle
Brace. Push down on the Handle Brace and
the front of the Hopper. Retighten Bolts and
check the shutoff.
Loading...