Mettler Toledo SAG285, SAG203F, SAG204 User Manual

SAG weighing modules

The simple solution for unusual weighing tasks

AG

1/10 d

On

O

ff

O/T

Rapid weight control of target weights from 0.1 g to 210 g

You are filling powders or liquids. You produce small parts from plastic. You make tablets and capsules. You want to
sort your products by weight. You control operations today with random sample checks.

You want to have full control over quality and limit material losses and rejects to a minimum.

Weighing under special conditions

You want to integrate a 5-, 3- or 4-decimal place balance in a robot system. You are looking for a compact weighing
unit with a separate display. You are weighing in a contaminated environment. You want to perform weight
determinations in a confined space or at low air pressure.

The weighing modules SAG285, SAG204 and SAG203F from METTLER TOLEDO provide a simple solution for these
and for many other weighing tasks.

The weighing modules were developed for use in production machinery, for highly accurate weighing under difficult
circumstances and conditions, as well as for accurate weight determination in procedures where timing is critical.

Cal

Menu

F

C

System description

The products SAG285, SAG204 and SAG203F consist of two parts:

• Compact, sealed weighing cell, which can be fixed to a flat base

• Electronic control unit with operating terminal, display and data interface

The weighing cell can be calibrated at any time by the press of a knob or via the data interface using the integrated
calibration weight. With the SAG285 und SAG204 a completely automatic calibration without intervention by the user is
also possible.

While the SAG285 resp. SAG204 has the readability of a classical analytical balance of 0.01 mg resp. 0.1 mg, the
SAG203F with reduced readability of 0.001 g offers an appreciably shorter stabilization time of just one second. It can
therefore be used, in situations where high throughput is important.

The typical areas of application are:

• “one shot” dispensing systems (preset amount is filled in one dose)

• Sorting or “on-line” weight control of small items (tablets, plastic moldings etc.)

• Robot controlled or automated determination of weight

• Weighing in confined fume hoods or fume chambers

• Weighing in a contaminated environment (poisons)

• Weighing under special pressure conditions, e.g. under vacuum

© Mettler-Toledo GmbH 2000 11780282B Printed in Switzerland 0010/40.12

Mettler-Toledo GmbH, Laboratory & Weighing Technologies, CH-8606 Greifensee, Switzerland
Phone [phone], Fax [phone], Internet: http://www.mt.com

*P11780282*

Dimensions

all dimensions in mm

Electronic control unit

Weighing cell

62

178

77

216

Ø

36

Ø

85

Mounting options

from below from above with height adjustment

56 56

92,5 ÷ 97*

82,5 ÷ 87*

130

M5 (3x)

10

185**

193

66

158

M4x16 (2x)

3 x M3

30

Ø

* Height adjustable ** Distance between the attachment points