INSTALLATION INSTRUCTIONS FOR PART 99-8150
APPLICATIONS
LEXUS ES SERIES
1992-1996
99-8150
KIT FEATURES
• DIN Mount Radio Provision with Pocket
• ISO Mount Radio Provision with Pocket
KIT COMPONENTS
A) Radio Housing • B) Trim Plate • C) Mounting Brackets • D) ISO Brackets • E) (6) Phillips Screws
B
A
D
TOOLS REQUIRED:
Small Flat Blade Screwdriver/ Panel Removal Tool
• Phillips Screwdriver • Socket Set
1-800-221-0932
© COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORA
C
www.metr
E
aonline.com
TION
99-8150
TABLE OF CONTENTS
Dash Disassembly
-
Lexus ES Series 1992-1996 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1
Kit Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Assembly
Kit
- DIN Mount Radio Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . . 3
- ISO Mount Radio Provision with Pocket. . . . . . . . . . . . . . . . . . . . . . . 4
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Final
*Note:
Refer also to the instructions included with the aftermarket radio.
99-8150 DASH DISASSEMBLY
LEXUS ES SERIES 1992-1996
Disconnect the negative battery ter-
1
minal to prevent an accidental short
circuit.
Unclip and remove the plastic trim
2
piece below the factory radio and
remove (2) Phillips screws exposed
underneath. (
3
Using a small flat blade screwdriver
release the clips securing the a/c vent
assembly and remove the assembly.
(Figure B)
Remove (2) Phillips screws inside of
4
vent cavity.
Pull the climate control/radio assem-
5
bly from the dash and disconnect the
wiring. (
Remove (2) Phillips screws and (4)
6
bolts per side to remove factory
brackets from climate controls and
radio.
Figure A)
(Figure B)
Figure C)
A
B
Continue to kit assembly.
C
1
99-8150 KIT PREPARATION
LEXUS ES SERIES 1992-1996
DIN MOUNT RADIO PROVISION WITH POCKET
ISO MOUNT RADIO PROVISON WITH POCKET
Install the factory climate controls
Install the mounting brackets to the
1
radio housing with (6) Phillips
Screws supplied. (
Continue to kit assembly.
A
Figure A)
2
into the assembled radio housing
and bracket assembly using the
screws from disassembly. (
Figure A)
2
99-8150 KIT ASSEMBLY
LEXUS ES SERIES 1992-1996
DIN MOUNT RADIO PROVISION WITH POCKET
Note: Refer also to the instructions included with the aftermarket radio.
Slide the DIN cage into the radio
1
housing and secure by bending the
metal locking tabs outward
Slide the aftermarket radio into the
2
cage until it snaps into place.
(Figure A)
Continue to final assembly.
(Figure A)
A
3
99-8150 KIT ASSEMBLY
LEXUS ES SERIES 1992-1996
ISO MOUNT RADIO PROVISON WITH POCKET
Note: Refer also to the instructions included with the aftermarket radio.
Mount the ISO brackets to the radio
1
using the screws supplied with the
radio.
(Figure A)
Slide the radio into the radio housing
2
until the ISO brackets snap into place.
(Figure A)
Snap the trim plate onto the front of
3
the radio housing.
TE:
NO
To remove the mounted aftermarket radio, unclip and remove the
ISO trimplate. Using a small flat blade
screwdriver, disengage the side clips
securing the ISO brackets to the
Radio Housing.
(Figure A)
(Figure B)
A
B
Continue to final assembly.
4
99-8150 FINAL ASSEMBLY
FINAL ASSEMBLY
A
(A) Strip wire ends back 1/2"
B
B) Twist ends together
C) Solder
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
1
proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative battery terminal and test the unit for proper operation.
2
Reassemble radio and dash assemblies in reverse order of disassembly.
3
D) Tape
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc . . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+)
Left Rear (-) . . . . . . . . . . . . . . Green / Black
. . . . . . . . . . . . .
Green
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
5
99-8150 INSTRUCTIONS
1-800-221-0932
REV. 07/28/10 © COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION INST99-8150
www.metraonline.com
Loading...