FMMOD02 INSTALLATION / USER GUIDE
1-800-221-0932 www.metraonline.com
CONTENTS
© COPYRIGHT 2004 METRA ELECTRONICS CORPORATION
• FM Modulator
• Mounting Hardware
A)
Power connections and on/off switch
B)
RCA audio input jacks
C)
Antenna connection to vehicle
D)
Antenna connection to radio
E)
FM frequency selector switch
MODULATOR CONNECTIONS
INST-FMMOD02
INSTALLATION & USER INSTRUCTIONS
INSTALLATION
A)
Disconnect the vehicles antenna from the radio and connect the
modulators antenna connections (C and D) to the vehicles antenna
and radio respectively. (In some vehicles antenna adapters are
needed, if this is the case see your nearest Metra retailer for the
correct adapters).
B)
For power connections (A), first find a suitable location to mount
the On/Off switch. Connect the red wire to a 12 volt switched wire,
and connect the black wire to the vehicles chassis ground.
C)
Connect the RCA audio jacks from the source that you want to go
through the radio to the RCA audio in put (B) jacks on the modulator.
D)
Select the FM frequency (E) on the side of the modulator that you
want to use, either 88.5 MHz or 88.9 MHz.
OPERATION
A)
Turn the modulator On
B)
TuC)rn the radio On and tune it to the frequency you selected on the
modulator
Once finished using the modulator, turn off for normal radio operation.
TROUBLESHOOTING
No sound
• Make sure power switch is on
• Make sure the source unit is on
• Make sure the radio is on the frequency selected on the modulator
• Make sure the power wire is connected to a 12v switched wire
You can hear other stations bleed through what you are listening to
• Make sure the radio is on the frequency selected on the modulator
• Try switching the frequency on the modulator.
Loading...