INFINITI/NISSAN HARNESS
USED WITH AHDT-01 AND AHDI-IO1
©Copyright 2007 Metra Electronics Corporation
1-800-221-0932 www.metraonline.com
AHDH-NS1
INSTALLATION INSTRUCTIONS
©Copyright 2007 Metra Electronics Corporation
1-800-221-0932 www.metraonline.com
AHDH-NS1 AHDH-NS1
Rev. 10/19/07 INSTAHDH-NS1
* READ IMPORTANT WARNING ON PAGE 1
BEFORE ATTEMPTING ANY INSTALLATION
5
AAPPPPLLIICCAATTIIOONNSS:
:
INFINITI
FX35/FX45 2003-2006*
G35 2003-2006*
M35/M45 2003-2005*
Q45 1998-2006*
QX56 2004-2006*
NISSAN
350Z 2003-2005
Altima 1998-2006
Armada 2005-2007
Frontier 2002-2007
Frontier 1998-2001*
Maxima 1998-2005
Murano 2003-2006
Pathfinder 1998-2005
Quest 1998-2006*
Sentra 1998-2005
Titan 2004-2007
Xterra 2000-2007
*NOTE: These models require
Metra’s 40-NI30 antenna adapters
to complete the install.
SCAN
PRESET #1
PRESET #2
PRESET #3
PRESET #4
PRESET #5
PRESET #6
Enters Scan mode. It will seek to the next found station in
HD mode continuously until pressed again. If in iPod mode,
it will scan through the next song. Pressing the Scan button a second time will disable the Scan mode.
In HD mode this acts like a typical preset button. In iPod
browse mode, this button goes to the next item in list.
In HD mode this acts like a typical preset button. In iPod
mode, this button acts as the ‘Escape’ button in order to
enter & exit “browse” mode.
In HD mode this acts like a typical preset button. In iPod
browse mode, this button selects the current item in the list
that’s displayed.
In HD mode this acts like a typical preset button. In iPod
browse mode,
this button goes to the previous item in list.
In HD mode this acts like a typical preset button.
In HD mode this acts like a typical preset button.
(Continued from page 3)
SECTION 2 - RADIO BUTTON
CONTROL-
controls for satellite receiver mode
SAT
AM/FM BUTTON
SEEK UP / DOWN
TUNE UP / DOWN
BUTTON
DESCRIPTION OF FUNCTION
Enters into ‘SAT’ mode & selects the next device. If HD-AM
was the pervious device that was playing, then HD-FM is
selected the next time, and vise versa. If an iPod is also
attached, then it will alternatively be chosen in the following
order : HD-AM > iPod > HD-FM > iPod
Pressing the Mode button a second time does nothing, the
unit must be deselected by hitting the AM/FM button first or
turning the radio off.
Deselects SAT (HD-AM, HD-FM, or iPod).
In HD mode, it seeks to the next or previous found station in
HD-AM or HD-FM. In iPod mode it goes to the next/previous playlist.
In HD mode, it will go to the next & previous station. If in
iPod mode, it will go to the next or previous song in the current playlist.
4
*IMPORTANT WARNING
THIS PRODUCT INCLUDES INSTRUCTIONS FOR INSTALLATION WHICH MUST BE
CAREFULLY FOLLOWED. THE INSTRUCTIONS ARE WORDED
IN SUCH A MANNER TO ASSUME THAT THE INSTALLER IS CAPABLE
OF COMPLETING THESE TYPE OF ELECTRONIC INSTALLATIONS.
IF YOU ARE UNCLEAR AS TO WHAT YOU ARE INSTRUCTED TO DO OR BELIEVE
THAT YOU DO NOT UNDERSTAND THE INSTRUCTIONS SO AS TO PROPERLY
AND SAFELY COMPLETE THE INSTALLATION YOU SHOULD CONSULT A TECHNICIAN WHO DOES HAVE THIS KNOWLEDGE AND UNDERSTANDING. FAILURE TO
FOLLOW THESE INSTRUCTIONS
CAREFULLY AND TO INSTALL THE INTERFACE AS DESCRIBED COULD
CAUSE HARM TO THE VEHICLE OR TO SAFETY SYSTEMS ON THE VEHICLE.
INTERFERENCE WITH CERTAIN SAFETY SYSTEMS COULD CAUSE HARM TO
PERSONS AS WELL. IF YOU HAVE ANY QUESTIONS IN THIS REGARD
PLEASE CALL THE HELP LINE OR THE METRA AT
1-800-221-0932 FOR ASSISTANCE.
1
AHDH-NS1
AHDH-NS1AHDH-NS1
INTRODUCTION
The AHDH-NS1 is to be used along with the AHDT-01 HD Tuner and the AHDII01 import HD interface (all sold separately) in the vehicles listed above. An
iPod may also be connected by using the XIAH-IPC iPod cable (sold separately). The factory radio will control the functions of the HD Tuner and the iPod
through the buttons on the radio. Also for those radios that do not display
text, the XIA-LCD display screen (sold separately), may be added to display
the HD and iPod text information.
The
AHDI-I01 emulates a factory CD Changer or an external Satellite Radio
Receiver, and on installation replaces either one.
The Nissan radios vary in what buttons they ha
ve. This manual covers as
many buttons as possible. The Radio connected to the
AHDI-I01,
most likely
,
will not have all the buttons listed in this document. However, the definitions
of the buttons displayed on the radio will still be valid.
The Nissan factor
y
radios fall into two categories, one tha
t is
satellite radio read
y and one tha
t
is capable of working with an
external CD changer.
HARNESS PREP
ARATION
If you are replacing an OEM external CD Changer, the AHDH-NS1 harness jumper
wire on the 20-pin connector (the bigger of the two) must be cut. Looking at the
cable harness, the jumper wire (White) between J1 Pins 7 and 16 must be cut.
Cut this jumper wire, and store it away with insulating tape. Once this is done,
the board will emulate an OEM external CD Changer.
If you are replacing an external Satellite Receiver, no modification to the cable
harness is required.
For factory satellite radio ready radios, use this operating procedure.
To enter HD or iPod mode, press the SAT button if the radio has one. If the radio
does not ha
ve a SA
T button,
press the BAND button.When listening to
HD radio
you can change the channel with TUNE UP or TUNE DOWN.The method of setting
resets and selecting presets is the same procedure specified in the radio instructions---to set a preset,
hold the button do
wn until you here a beep; to select a
preset,
just press the desired button.
FACTORY SATELLITE RADIO
OPERATION
EXTERNAL CD CHANGER RADIO
OPERATION
For factory CD changer equipped radios, use this operating procedure. To enter
HD radio mode or iPod mode, press the CD/CHG button.
When listening to HD radio you can change the channel with TUNE UP or TUNE
DOWN.
When listening to the iPod, you can change the track by using the TUNE UP and
TUNE DOWN button. If you want to scan though the songs then press the SCAN
button. When you want to end the scan, press the SCAN button again. The song
that was playing when scan was turned off will continue to play.
To start browsing the iPod, press 2 to enter browse mode. Then you can press
either 1 or 4 to go up or down the selection of categories that can be browsed.
When you find the category you would like to browse, press 3. Browse though
the selections using the same buttons (1 or 4) until you find your choice, and then
press 3. Button 3 enters the choice that you have picked. At any time you can
end the browsing of the category or browsing mode completely by pressing 2.
SECTION 1 - OPERATING
INSTRUCTIONS
3
pTo change to a different playlist, press either SEEK UP or SEEK DOWN. The iPod
will advance to the next playlist that has songs. If you want to scan though the
songs, then press the SCAN button. When you want to end the scan mode, press
the SCAN button again. The song that was playing when scan was turned off will
continue to play.
When you first enter the iPod mode, buttons 1 to 4 can be used to browse the
iPod categories. Press buttons 1 through 4 until you hear a beep when pressing
each one. Once that is done, you can browse the iPod. Press 2 to enter browse
mode. Then you can press either 1 or 4 to go up or down the selection of categories that can be browsed. When you find the category you would like to
browse, press 3. Browse though the selections using the same buttons (1 or 4)
until you find your choice and then press 3. Button 3 enters the choice that you
have picked. At any time you can end the browsing of the category or browsing
mode completely by pressing 2.
PORT OVERVIEW
1) This port is used with the optonal XIA-LCD display.
2) This port is used with the HD cable included with AHDT-01 tuner.
3) This port is used with the iPOD cable XIAH-IPC or the AUX IN cable XIAH-RCA.
1
2
3
2
Continued on page 4
To enter iPod mode, press the SAT or BAND button, and observe “IPOD IN” on
the display.When listening to the iPod, you can change the track by using the
TUNE UP and TUNE DOWN buttons.
Loading...