Page 1
INSTALLATION INSTRUCTIONS FOR PART 99-8216
APPLICA TIONS
Toyota
Yaris
2007-2010
(Excludes models equipped with power package)
99-8216
KIT FEATURES
• DIN Radio Provision with pocket
• ISO Radio Provision with pocket
KIT COMPONENTS
A) Radio Housing B) Housing Brackets-3 Door C) Housing Brackets-4 Door D) ISO Snap In Brackets E) Trim Plate
B
C
A
Phillips Screwdriver • Socket Wrench •
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wir
e harness:
• 70-1761 Toyota 1987-up
• TYTO-01 Toyota amp interface harness 2003-up
Antenna adapter:
• Not required
TOOLS REQUIRED:
Small Flat Blade Screwdriver or
D
E
Panel Removal Tool
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
Page 2
99-8216
TABLE OF CONTENTS
Dash Disassembly
Yaris 2007-2010 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Kit
Assembly
Din Mount Radio Provision with pocket. . . . . . . . . . . . . . . . . . 2
ISO Mount Radio Provision with pocket. . . . . . . . . . . . . . . . . . 3
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Final
K
NOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take
steps toward a better tomorrow.
Page 3
99-8216
YARIS 2007-2010
Disconnect the negative battery
1
terminal to prevent an accidental
short circuit.
2
Unclip the bottom trim panel located
underneath the A/C Controls.
Figure A)
Unclip the two side trim panels that
3
surround the A/C Controls and Radio.
(Figure A)
DASH DISASSEMBLY
A
B
Unclip the Instrument trim Panel
4
surrounding the Speedometer and
gauges.
Unclip the Radio/AC Vents trim
5
Panel.
Remove (4) Phillips screws securing
6
radio. (Figure C)
Unplug and remove radio.
7
Continue to kit assembly.
(Figure B)
(Figure B)
C
1
Page 4
99-8216
DIN MOUNT RADIO PROVISION
NOTE: Refer also to the instructions
included with the aftermarket radio.
Slide the Mounting Brackets onto the
1
sides of the Radio Housing until the
side clips engage. Note:
marked 8216-3L and R for the 3
door Yaris and 8216-4L and R for the
4 door Yaris. (Figure A)
Slide the DIN cage into the Radio
2
Housing and secure by bending the
metal locking tabs outward.
(Figure B)
Tabs are
KIT ASSEMBLY
A
B
Slide the aftermarket radio into the
3
cage until it snaps into place.
(Figure C)
Continue to final assembly.
C
2
Page 5
99-8216
ISO MOUNT RADIO PROVISION
NOTE: Refer also to the instructions
included with the aftermarket radio.
Slide the Mounting Brackets onto the
1
sides of the Radio Housing until the
side clips engage. Note:
marked 8216-3L and R for the 3
door Yaris and 8216-4L and R for the
4 door Yaris. (Figure A)
Tabs are
KIT ASSEMBLY
A
B
Mount the ISO Brackets to the
2
aftermarket radio using the screws
supplied with the radio. (Figure B)
Slide the radio into the radio opening
3
until the side clips snap into place.
(Figure C)
Snap the Trim plate onto the front the
4
Radio Housing assembly. (Figure C)
C
Continue to final assembly.
3
Page 6
99-8216
FINAL ASSEMBLY
FINAL ASSEMBLY
Locate the factory wiring harness in the dash and make the connection as shown.
1
Metra recommends using the proper mating adapter and making the connections
as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative battery terminal and test the unit for proper operation.
2
3
Reassemble radio and dash assemblies in reverse order of disassembly.
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the head
unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually
tape off ends of any unused wires to prevent electrical short circuit.
A
B
C
D
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D)
METRA / EIA WIRING CODE
12V Ignition / Acc . . . Red
12V Batt / Memory . . Yellow
Ground . . . . . . . . . . . Black*
Power Antenna . . . . . Blue
Amp Turn-On . . . . . . Blue / White
Amp Ground . . . . . . . Black / White
Illumination. . . . . . . . Orange
Dimmer . . . . . . . . . . Orange / White
Right Front (+) . . . . . Gray
Right Front (-) . . . . . . Gray / Black
Left Front (+) . . . . . . White
Left Front (-) . . . . . . . White / Black
Right Rear (+). . . . . . Violet
Right Rear (-) . . . . . . Violet / Black
Left Rear (+) . . . . . . . Green
Left Rear (-) . . . . . . . Green / Black
Tape
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
4
Page 7
99-8216
NOTES
5
Page 8
99-8216 INSTRUCTIONS
1-800-221-0932 www.metraonline.com
REV. 04/26/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-8216
Loading...