Metra Electronics 99-7875T, 99-7875 User Manual
INSTALLATION INSTRUCTIONS FOR PART 99-7875/99-7875T
APPLICATIONS
Honda Accord 2008-2010
(For Non-Navigation models with Dual Zone Climate controls)
Honda Accord Crosstour 2010
99-7875/99-7875T
KIT FEATURES
• Painted To Match Factory Dash
99-7875=Charcoal, 99-7875T=Taupe
• DIN Radio Provision with Pocket
• ISO Mount Radio Provision with Pocket
• Double DIN Radio Provision
• Stacked ISO Mount Units Provision
• A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate • D) Double DIN Brackets
• E) Double DIN Trim Plate • F) Pocket
B
A
E
F
Small Flat Blade Screwdriver/ Panel Removal Tool
• Phillips Screwdriver • Cutting Tool
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
• 70-1729 - Honda harness 2008-up
• 70-1730 - Honda amp interface harness 2008-up
Antenna Adapter:
• 40-HD10 - Honda antenna adapter 2005-up
TOOLS REQUIRED:
1-800-221-0932
© COPYRIGHT 2008-2010 METRA ELECTRONICS CORPORATION
C
D
www.metraonline.com
99-7875/99-7875T DASH DISASSEMBLY
HONDA ACCORD 2008-10 / CROSSTOUR 2010
Disconnect the negative battery ter-
1
minal to prevent an accidental short
circuit.
2
Unclip and remove the trim panel
from above the glove box at the right
side of the factory radio. (
3
Unclip and remove the trim panel at
the left side of the factory radio.
(
Figure B)
4
Remove the (2) Phillips screws from
the left and right side of the of the
factory radio. (
5
Unclip and remove the top of the center console including the cup holders.
(
Figure D)
6
Remove (2) Phillips screws at the bottom edge of the pocket assembly.
(
Figure E)
Figure C)
Figure A)
A
B
C
Remove (2) Phillips screws facing up
7
inside of the pocket below the factory
radio. (
Figure F)
8
Unclip and remove the pocket assembly. (
Figure G)
Continue on page 2.
E
D
1
99-7875/99-7875T DASH DISASSEMBLY
HONDA ACCORD 2008-10 / CROSSTOUR 2010
9
Remove (2) Phillips screws facing up
on the bottom of the factory radio.
(
Figure H)
10
Unclip the factory radio assembly.
Unplug and remove the radio assem-
Figure I)
bly. (
11
Remove (6) Phillips screws securing
the climate controls to the factory
radio assembly and remove the controls from the assembly. (Retain the
screws and climate controls for reuse during kit preparation.)
12
Remove (4) Phillips screws securing
the a/c vents to the factory radio
assembly and remove the a/c vent
from the assembly. (Retain the
screws and a/c vents for re-use during kit preparation.)
F
G
13
Unclip and remove the hazard
switch/passenger air bag light
assembly. (Retain the hazard
switch/passenger air bag light
assembly for re-use during kit preparation.)
14
Remove (4) Phillips screws securing
trim panel at the bottom edge of the
factory radio assembly and remove
the trim panel. (Retain the screws
and trim panel for re-use during kit
preparation.)
15
Remove (9) clips from the back of the
factory radio assembly. (Retain the
clips for re-use during kit preparation.)
Continue to kit preparation.
H
I
2
Loading...