Disconnect the negative battery terminal to prevent an accidental short
circuit.
2
Twist and slide down the cover at the
base of the shift knob. (Figure A)
3
Remove the retaining clip at base of
A
DASH DISASSEMBLY
B
shift knob and pull up to remove.
(Figure B)
4
Unclip and remove panel surrounding
shift knob. (Figure C)
5
Remove (2) Phillips screws at the bottom of the radio panel and unclip and
remove.
(Figure E)
C
E
1
99-7404
6
Remove (2) Phillips screws at the bottom
of the display panel and unclip and remove
F
DASH DISASSEMBLY
the panel.
7
Remove (4) Phillips screws to remove
the audio/climate control/display as
one unit.
8
Remove (4) Phillips screws from each
side of radio/tuner to remove from
audio/climate control/display bracket
assembly.
9
Remove the (4) Phillips screws securing the factory climate control button
assembly to the radio panel and
remove. Note: Retain all hardware to
(Figure F)
(Figure G)
G
H
be used in Kit Assembly.
10
Remove (4) Phillips screws securing
the factory pocket assembly to the
radio panel and remove. Note: Retain
all hardware to be used in Kit
Assembly.
(Figure I)
(Figure H)
I
2
99-7404
ISO DIN HEAD UNIT PROVISIONS:
Position the aftermarket radio
1
into audio/climate control/display bracket assembly and
secure using the bottom (2)
Phillips screw positions and the
factory hardware. (Figure A)
Install the (4) supplied retaining
2
clips onto the 99-7404 in the
same locations as the factory
radio panel.
(Figure B)
Using the factory hardware
3
A
B
C
KIT ASSEMBLY
secure the factory climate
control button assembly into
the 99-7404.
Using the factory hardware
4
secure the factory pocket
assembly into the 99-7404.
(Figure D)
(Figure C)
D
3
99-7404
A
FINAL ASSEMBLY
B
C
D
Locate the factory wiring har-
1
ness in the dash. Metra recommends using the proper mating
adapter and making the connections as shown. (Isolate and
individually tape off the ends of
any unused wires to prevent
electrical short circuit)
A)Strip wire ends back 1/2"
B)Twist ends together
C)Solder
D)Tape
Re-connect the negative battery
2
terminal and test the unit for
proper operation.
Reassemble in reverse order of
3
disassembly using the 99-7404
instead of the factory radio
panel.