Page 1
INSTALLATION INSTRUCTIONS FOR PART 99-7325
APPLICATIONS
Hyundai Santa Fe
2007-2010
(excludes 2010 NAV models)
99-7325
KIT FEATURES
• DIN Radio Provision with Pocket
• ISO Radio Provision with Pocket
KIT COMPONENTS
A) Radio Housing B) ISO Brackets C) Trim Plate
A
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
• 70-7302 - Hyundai Harness 2007-up
• 70-7305 - Hyundai / KiA Harness 2009
Antenna Adapter:
• 40-KI11 - 2009-10 Santa Fe Adapter
Small Flat Blade Screwdriver/ Panel Removal Tool
1-800-221-0932
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
B
TOOLS REQUIRED:
• Phillips Screwdriver
C
www.metraonline.com
Page 2
99-7325
K
NOWLEDGE IS POWER
Enhance your installation and fabrication skills
by enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com
or call 800-354-6782 for more information
and take steps toward a better tomorrow.
TABLE OF CONTENTS
Dash Disassembly
- Hyundai Santa Fe 2007-2010 .......................................1
Kit
Assembly
- DIN Radio Provision with Pocket ..................................2
- ISO Radio Provision with Pocket ...................................3
Final
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
*Note:
er also to the instructions included with the aftermarket radio.
Ref
Page 3
99-7325 DASH DISASSEMBLY
HYUNDAI SANTA FE 2007-2010
Disconnect the negative battery ter-
1
minal to prevent an accidental short
circuit.
2
Remove (1) Phillips screw from the
right side of the panel below the
steering column then unclip and let
right side of panel hang.
Unclip and remove the cover above
3
the clock on top of panel surrounding
the radio.
4
Unclip and remove the panel extending across the dash below the a/c
control and above the glove box
including the ash tray.
5
Remove (2) Phillips screws then
unclip and remove the panel surrounding the radio including the a/c
vents.
(Figure B)
(Figure D)
(Figure A)
(Figure C)
A
B
Remove (4) Phillips screws securing
6
the radio. Unplug and remove radio.
Continue to kit assembly.
D
C
1
Page 4
99-7325 KIT ASSEMBLY
DIN RADIO PROVISION WITH POCKET
*Note: Refer also to the instructions included with the aftermarket radio.
A
Slide the DIN cage into the Radio
1
Housing and secure by bending the
metal locking tabs outward.
2
Slide the aftermarket radio into the
cage until it snaps into place.
Continue to final assembly.
(Figure A)
(Figure B)
B
2
Page 5
99-7325 KIT ASSEMBLY
ISO RADIO PROVISION WITH POCKET
*Note: Refer also to the instructions included with the aftermarket radio.
A
Mount the ISO Brackets to the after-
1
market radio using the screws supplied with the radio.
2
Slide the radio into the radio opening
until the side clips snap into place.
(Figure B)
Snap the trim plate onto the front of
3
the Radio Housing.
Continue to final assembly.
(Figure A)
(Figure B)
B
3
Page 6
99-7325 FINAL ASSEMBLY
FINAL ASSEMBLY
A
(A) Strip wire ends back 1/2"
B
B) Twist ends together
C) Solder
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
1
proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative battery terminal and test the unit for proper operation.
2
Reassemble radio and dash assemblies in reverse order of disassembly.
3
D) Tape
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc . . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
4
Page 7
99-7325
NOTES
5
Page 8
99-7325 INSTRUCTIONS
1-800-221-0932
REV. 04/27/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-7325
www.metraonline.com
Loading...