Page 1
APPLICA
TIONS
INST
ALLATION INSTRUCTIONS FOR PART 99-6515
WIRING &
ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness: • XSVI-6515-NAV - Fiat interface
Antenna Adapter: • 40-EU56
Panel Removal Tool • Phillips Screwdriver • Socket Wrench • 86-5618 Radio Removal Keys
TOOLS REQUIRED
F
iat 500 2012-up
99-6515B, 99-6515W
• A) Radio Housing • B) ISO Brackets • C) ISO Trimplate
KIT FEATURES
KIT COMPONENTS
• DIN head unit provisions
• ISO DIN Head unit provisions
• P
ainted 2 colors
99-6515B = Black, 99-6515W = White
BA
C
Page 2
1. Remove the (4) radio removal tool
covers from the factory radio. (Figure A)
2. Using Metra’s 86-5618 radio removal
tools pull the factory radio from the
dash. (Figure B)
3. Remove (1) 10 mm bolt from the center
rear of the metal radio support and (2)
Phillips screws from both sides of the
support then remove it from the sub
dash. (Figure C)
Fiat 500 2012-up
Dash Disassembly 99-6515
(Figure C)
(Figure A)
(Figure B)
Page 3
1. Trim the area at the bottom of the sub
dash opening to allow for clearance of
the radio housing. (Figure A)
2. Secure the radio housing to the sub
dash with the factory hardware.
(Figure B)
Continue to kit assembly
Kit Preparation
99-6515
(Figure A)
(Figure B)
Areas to be trimmed
Page 4
DIN head unit provision
Kit Assembly 99-6515
(Figure A)
(Figure B)
1. Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs down. (Figure A)
2. Slide the aftermarket head unit into
the cage and secure. (Figure B)
3. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
4. Reassemble dash in reverse order
of disassembly.
Page 5
1. Mount the ISO Brackets to the head unit
with the screws supplied with the unit.
(Figure A)
2. Slide the head unit into the radio
opening until the side clips engage.
(Figure B)
3. Snap the Trim plate into the
Radio Housing. (Figure C)
4. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
5. Reassemble dash in reverse order
of disassembly.
ISO DIN head unit provisions
Kit Assembly 99-6515
(Figure A)
(Figure B)
(Figure C)
Loading...