Metra Electronics 99-3528 Installation Manual

Page 1
INSTALLATION INSTRUCTIONS FOR PART 99-3528
APPLICA TIONS
2004-2006 Pontiac GTO
99-3528
KIT FEATURES
• DIN Head Unit Provisions with Oversized Pocket
KIT COMPONENTS
A) Radio Housing
86-3528 Radio Removal Keys • Flat Blade Screwdriver • Phillips Screwdriver
TOOLS REQUIRED:
Page 2
99-3528
2004-2006 PONTIAC GTO
A
Disconnect the negative battery ter-
1
minal to prevent an accidental short circuit.
2
Using the radio removal keys, pull the factory head unit from the dash and disconnect the wiring.
Unsnap and remove the trim panel at
3
the top center of the dash above the A/C vents and remove (4) Phillips screws.
(Figure B)
(Figure A)
B
DASH DISASSEMBLY
Remove (1) Phillips screw from
4
inside lower open storage area where center console and dash meet.
Unsnap and remove center console
5
(open center armrest/ storage com­partment and work forward).
(Figure D)
(Figure C)
C
D
Page 3
99-3528
2004-2006 PONTIAC GTO
Remove (2) Phillips screws exposed
6
at the bottom of the center panel surrounding radio and remove panel.
(Figure E)
Unclip and remove trim panel sur-
7
rounding radio and A/C controls.
Remove (3) Phillips screws holding
8
"cage" in radio opening.
(Figure F)
E
F
DASH DISASSEMBLY (cont’d)
Pull down on the "cage" from the
9
opening inside on the top and remove.
(Figure G)
G
Page 4
Slide the DIN cage into the Radio
1
Housing and secure by bending the metal locking tabs down.
Slide the aftermarket head unit into
2
the cage and secure.
(Figure A)
(Figure B)
99-3528
A
KIT ASSEMBLY
B
Page 5
99-3528
A
FINAL ASSEMBLY
B
C
D
Locate the factory wiring harness
1
in the dash. Metra recommends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit)
A) Strip wire ends back 1/2" B) Twist ends together C) Solder D) Tape
Re-connect the negative battery
2
terminal and test the unit for proper operation.
Reassemble in reverse order of
3
disassembly leaving the cage (removed in step 9 of dash disas­sembly) out and snapping the 99­3528 in place of the factory radio.
METRA ACCESSORIES
STEREO DASH KITS
Loading...