Metra Electronics 99-3100, AW310SA User Manual
KIT FEATURES
Shaft and
DIN unit
provisions
99-3100
AW-310SA
INSTALLATION
KIT COMPONENTS
Radio Housing
Shaft
Supports
(2) #10
Phillips Screws
INSTRUCTIONS
APPLICATIONS
CAR PAGE
SATURN
(All models) 1995-99...............................................1-2
rev. 290601
TOOLS REQUIRED
Phillips screwdriver
Adjustable wrench
Socket wrench
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
ALL VEHICLES
3 4
A
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (2)
pop-clips from the sides of the radio trim bezel. Unclip the radio trim bezel, disconnect the
switch wiring and remove the bezel. Remove (2) 7mm hex-head screws securing the top of
the factory head unit and disconnect the wiring.
2
Fig. A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
5
Locate the (4) mounting locations in the subdash.
Fig. B
2-SHAFT HEAD UNITS: Snap the Shaft Supports into the Radio Housing. Slide the
aftermarket head unit into the kit and secure with shaft nuts. (see Fig. A)
DIN HEAD UNITS: Slide the DIN cage into the kit and secure by bending the metal locking
tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B)
1
"B"
"A"
"B"
"A"
Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit
assembly to the sub-dash with (2) 7mm hex-head screws previously removed in step #1 ("A")
and (2) #10 Phillips screws supplied ("B").
2