Metra Electronics 95-8903S Installation Manual

Download

Page 1

METRA. THE WORLD’S BEST KITS.™

APPLICATIONS

1-800-221-0932

metraonline.com

INSTALLATION INSTRUCTIONS FOR PART 95-8903S

Subaru Legacy & Outback 2010-up

(Non-navigation radios only)

95-8903S

• DDIN radio provision

• Stacked ISO radio provision

• Painted silver

Panel Removal Tool • Phillips Screwdriver • Socket Wrench • Small Flat Blade Screwdriver

• A) DDIN Trim plate • B) DDIN Brackets

TOOLS REQUIRED

KIT FEATURES

KIT COMPONENTS

WIRING & ANTENNA CONNECTIONS (Sold Separately)

Wiring Harness:

• 70-8901 Subaru Harness 1990-Up

• 70-7552 Nissan Harness 2007-Up Antenna Adapter:

• 40-SB10 Subaru Antenna Adapter 2005-Up

Page 2

Table of Contents

Dash Disassembly

– 2010-up Subaru Legacy 3

Kit Assembly

– Double DIN/Stacked ISO DIN Head Unit Provision 4

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.

Metra recommends MECP certified technicians

95-8903S

Caution

Metra recommends disconnecting the negative battery terminal before beginning any installation. All accessories, switches, and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition.

*NOTE: Refer also to the instructions included with the aftermarket radio.

Page 3

1. Disconnect the negative battery terminal to prevent an accidental short circuit.

2. Unclip and remove the radio trim panel including the a/c vents. (Figure A)

3. Remove (4) Phillips screws securing the factory radio.

Continued to kit assembly

Dash Disassembly

95-8903S

(Figure A)

Page 4

Kit Assembly 95-8903S

1. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation.

2. Attach the Double DIN brackets to the Double DIN trim plate. (Figure A)

3. Slide the Double DIN head unit or stacked ISO head units into the bracket/ radio housing assembly and secure the Double DIN head unit or stacked ISO head units to the assembly using the screws supplied with the radio. (Figure B)

4. Reassemble dash in reverse order of disassembly.

Double DIN/Stacked ISO DIN head

unit provisions

(Figure A)

(Figure B)

Page 5