Page 1
APPLICA
TIONS
C
AUTION: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
NOTE: Refer to the instructions included with the
aftermarket radio.
INSTALLATION INSTRUCTIONS FOR PART 95-6518B
• Double DIN radio provision
• Painted matte black
• A) Radio housing • B) Brackets
KIT FEATURES
KIT COMPONENTS
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • XSVI-6523-NAV Chrysler interface 2013-up
Antenna Adapter: • 40-EU55 – amplified antenna adapter
R
am Trucks 2013-up
(without 8.4 inch touchscreen)
Modifica
tions to factory radio cavity required for this installation
95-65
18B
B
• Panel removal tool • Phillips screwdriver
• Socket Wrench
TOOLS REQUIRED
A
Page 2
95-6518B
1. Remove liner inside tray at the top
center of the dash and remove two
torx screws. (Figure A)
2. Unsnap and remove radio panel.
(Figure B)
3. Remove four screws and remove
radio. (Figure C)
4. The factory rear support will need
to be cut or removed to allow
space for a new radio. The bottom
section can be removed with
two cuts at the bottom corners.
(FigureD)
Continue to kit assembly
Dash Disassembly
115V AC
150W
(Figure A)
(Figure B)
(Figure C)
(Figure D)
Remove shaded area
Page 3
95-6518B
Kit Assembly
Double DIN radio provisions
Note: For proper orientation, the
locating tabs on the Radio Housing
are more to the top of the kit than
bottom. (Figure A
1. Rotate the brackets into the
radio housing. (Figure B)
2. Slide the radio into the bracket/
radio housing assembly and secure
using the screws supplied with the
radio. (Figure C)
3. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from
Metra and/or AXXESS.
4. Reassemble dash in reverse order
of disassembly.
(Figure C)(Figure B)
(Figure A)
Top of housing
Loading...