INSTALLATION INSTRUCTIONS FOR PART 95-5817
APPLICATIONS
FORD
Explorer 1995-2001
Explorer Sport Trac 2001-2005
Ranger 1995-2009
Crown Victoria 1995-2009
Econoline 1997-2008
Escape 2001-2007
Windstar 1999-2003
Excursion 2000-2005
Super Duty 1999-2004
LINCOLN
Continental 1995-1997
Mark VIII 1996-1998
Town Car 1995-2002
A
MAZD
B-Series Pickup 1995-2009
Y
MERCUR
Grand Marquis 1995-2009
Marauder 2003-2004
Mountaineer 1997-2001
Mariner 2005-2007
95-5817
KIT FEATURES
• Double DIN Unit Provision
• Stacked ISO Mounts Units Provision
NOTE: Sub dash modifications are
necessary to use this dash kit.
You will need to trim the sub dash
to gain suitable depth and height.
NOTE: Once the kit is snapped in,
removed without dash panel removal.
KIT COMPONENTS
• A)
Double Din Trim Brackets • B) Filler Bar
it cannot be
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
• See www.metraonline.com for specific interface
A
applications
Antenna Adapter:
Not required.
TOOLS REQUIRED:
Dremel or Suitable Cutting Tool •Small Flat Blade Screwdriver
• Panel Removal Tool • Socket Wrench
1-800-221-0932
© COPYRIGHT 2009-10 METRA ELECTRONICS CORPORATION
•
Metra 86-5618 Removal Keys
www.metraonline.com
B
95-5817
K
NOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
TABLE OF CONTENTS
Dash Disassembly
- All Vehicles . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Kit
Assembly
- Double DIN/Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . . 2
Final
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
*Note:
Refer also to the instructions included with the aftermarket radio.
95-5817 DASH DISASSEMBLY
ALL VEHICLES
Disconnect the negative battery terminal to prevent an accidental short circuit.
1
2
Using the Metra 86-5618 removal keys, slide the radio out of the radio cavity.
Unplug and remove the radio. (
Cut and remove obstructions in dash cavity. (Be careful not to cut into harnesses or
3
electronic components)
Continue to kit assembly.
Figure A)
1
95-5817 KIT/FINAL ASSEMBLY
DOUBLE DIN/STACKED ISO MOUNT
UNIT(S) PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
NOTE: Sub dash modifications are necessary to use this dash kit. You will need to
trim the sub dash to gain suitable depth and height.
NOTE: Once the kit is snapped in, it cannot be removed without dash panel removal.
A
1
Attach the double DIN brackets to
the double DIN or stacked ISO Mount
unit(s) using the screws supplied
with the unit(s).
(Figure A)
2
Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter and making the connections as shown.
(Isolate and individually tape off the
ends of any unused wires to prevent
electrical short circuit).
3
Re-connect the negative battery terminal
and test the unit for proper operation.
Continued on page 3.
(Figure B)
B
A
B
C
D
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
2
95-5817 KIT/FINAL ASSEMBLY
FINAL ASSEMBLY
NOTE: Major sub dash modifications are necessary to use this dash kit. You will
need to trim the sub dash to gain suitable depth and height.
Continued from page 2.
C
Slide the double DIN radio or stacked
4
ISO Mount unit assembly into the
modified sub dash until it clicks into
place.
5
Clip the filler bar into the bottom of
the radio opening under the radio
assembly with the rounded edges
facing toward the dash. T
ip: Hook
one side in then push the other side
in until it clips.
(Figure C)
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions
included with the head unit. Metra recommends making connections shown below; Strip, Splice,
Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short
circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc . . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
TE:
When a Black wire is not present, ground radio to vehicle chassis. All colors may not be
*NO
present on all leads due to manufacturer’s specifications.
Enjoy your newly installed radio!
3
95-5817
NOTES
4
95-5817
NOTES
5
95-5817 INSTRUCTIONS
1-800-221-0932
REV. 06/08/10 © COPYRIGHT 2009-10 METRA ELECTRONICS CORPORATION INST95-5817
www.metraonline.com
Loading...