Page 1
INSTALLATION INSTRUCTIONS FOR PART 89-9400
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2004 METRA ELECTRONICS CORPORATION
KIT FEATURES
APPLICATIONS
LAND ROVER
Discovery / Discovery II 1994-2004
DIN Head unit provision
A) Trim Plate
KIT COMPONENTS
TOOLS REQUIRED:
89-9400
A
86-9001 Radio Removal Tool
9E
TABLE OF CONTENTS:
Dash Disassembly ................ 1
Kit Assembly .......................... 2
Final Assembly ...................... 3
Page 2
89-9400
DASH DISASSEMBLY
LAND ROVER DISCOVERY AND DISCOVERY II
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
2
A
Insert the long ends of the
86-9001 into the slots on the
factory radio and pull out to
remove. (Figure A)
1
Page 3
KIT ASSEMBLY
89-9400
2
1
Snap the 89-9400 trim plate
into the bottom of the subdash opening.
(Figure A)
2
Slide the DIN cage into the
space above the 89-9400 and
secure by bending the metal
locking tabs outward.
(Figure B)
3
Slide the aftermarket head
unit into the DIN cage until
secure.
A
B
Page 4
3
FINAL ASSEMBLY
89-9400
1
Locate the factory wiring harness in the dash. Metra recommends using the proper mating
adapter and making the connections as shown. (Isolate and
individually tape off the ends of
any unused wires to prevent
electrical short circuit)
2
Re-connect the negative battery
terminal and test the unit for
proper operation.
3
Reassemble radio and dash
assemblies in reverse order of
disassembly.
A
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
B
C
D
Loading...