Page 1
APPLICA
TIONS
C
AUTION: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
NOTE: Refer to the instructions included with the
aftermarket radio.
INSTALLATION INSTRUCTIONS FOR PART 82-9600
• Mounts aftermarket 6” to 6.5” speakers into
factory speaker locations.
• A) (2)
speaker adapters
• B) (6) #8 x 1” Pan-head Phillips screws
KIT FEATURES
KIT COMPONENTS
• P
anel removal tool • Phillips screwdriver • Socket Wrench (T-25, T-27, 6mm or 3/16 hex)
TOOLS REQUIRED
Har
ley-Davidson 1998-2013
(FL models with fairings)
82-9600
A B
Page 2
82-9600
Fairing Disassembly
FLH/Batwing models:
1. Cover the front fender.
2. Remove (2) T-27 Torx bolts from inner
fairing (under mirrors) (Figure A, step 2)
3. Remove (2) T-27 Torx bolts from outer
edges of inner fairing near the fork tubes
(facing forward) (Figure A, step 3)
4. Remove (3) T-27 Torx bolts from bottom
edge of windshield. (Figure A, step 4)
NOTE: Windshield and fairing
will be loose once these screws
are removed. Use extreme
caution not to damage fairing or
windshield.
5. Remove windshield taking caution that
the outer fairing is loose.
(Figure A)
Step 2 Step 2
Step 3
Step 4
Page 3
82-9600
FLH/Batwing models: (cont.)
6. Lift away and unplug headlight to
remove outer fairing. (Figure B)
7. Unbolt and remove inner fairing support
brackets from each side (3/16” Allen &
T-25 Torx screws).
Note the Torx screw is also a shared
speaker screw. (Figure C)
8.
Remove the remaining speaker
screws and the speaker.
Fairing Disassembly
(Figure B) (Figure C)
Page 4
82-9600
Fairing Disassembly
Roadglide/Sharknose models
1. Loosen (6) T-25 Torx bolts from
bottom, middle and top of left and
right sides of the inner fairing.
(Figure A)
(Figure A)
Step 1 Step 1
Page 5
82-9600
Fairing Disassembly
Roadglide/Sharknose models (cont.)
2. Use a 1/2” socket or box wrench
to remove the (2) acorn nuts that
hold each turn signal at the lower
fairing. Let the signals hang loose.
(Figure B)
3. Lift away the fairing, unplug the
headlights and remove.
4. Remove the speaker screws
and the speaker.
(Figure B)
Page 6
82-9600
Kit Assembly
1. Using 3 of the screws in the
provided hardware, mount the
speaker adapter to the inner
fairing. The 4th inner bottom screw
locations are not used on FLH/
batwing models. For Road Glide
models, rotate the adapter until
the notches in the adapter do not
hit the factory mounting posts and
the flat spots on the outside of the
adapter are toward the outer edge
of the fairing. (Figure A)
2. Mount the new speaker with
the hardware provided with the
speakers. (Figure B)
(Figure A) (Figure B)
Loading...