Metra Electronics 70-5511, 70-5512 User Manual
FINAL WIRING CONNECTIONS
Power
Harness
Amplifier
Integration
Plug
Amplifier
Integration
Plug
Make wiring connections using the EIA color code chart shown below and the
instructions included with the head unit. Metra recommends making connections
as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends
of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray / Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s
specifications.
STRIP
SPLICE
SOLDER
TAPE
INSTALLATION
INSTRUCTIONS
70-5511
70-5512*
Ford Premium Sound System Harness
To Integrate Aftermarket Radio
with Factory Amplifiers and Speakers
KIT COMPONENTS
70-5511 70-5512 *
*Requires 70-1704
power harness
TOOLS REQUIRED FOR INST
• Cutting Tool • Tape • Crimping Tool • Connectors
ALLATION
4
1-800-221-0932 www.metraonline.com
REV. 04/13/06 INST70-5511
©Copyright 2004 Metra Electronics Corporation
TO INSTALL AN AFTERMARKET RADIO WHILE
(A) Strip wire ends back 1/2"
(B) Twist ends together
(C) Solder
(D) Tape
KEEPING THE FACTORY AMPLIFIER AND SPEAKERS
Disconnect the negative battery terminal
1
to prevent an accidental short circuit.
Unplug the power and output connectors
2
from the factory radio.
Splice the wire from the aftermarket
3
radio to the power and amplifier integration harnesses using the color code on
page 4 and the instructions included with
the aftermarket radio.
(Figure B)
(Figure A)
NOTES
A
B
Plug the power and amplifier integration
4
harnesses into the factory power and
output connectors.
Re-connect the negative battery terminal
5
and test the unit for proper operation.
1
2
3
Loading...