Metra JP-1014 Installation Guide

INSTALLATION INSTRUCTIONS
JP-1014
KIT COMPONENTS
• A) Speaker pods (L&R) • B) Speaker harness adapter (2)
A B
®
Metra. The World’s Best Kits.
MetraOnline.com © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION REV. 12/12/19 INSTJP-1014
Jeep Wrangler (JL) 2018, Wrangler 2019-Up
Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle specific applications
KIT FEATURES
• Driver and passenger specific dash replacement sealed speaker pods to install 6” to 6.75” speaker
• Mounting positions for Chrysler three hole mount used by specific speaker manufacturers such as Alpine
• Sealed enclosure with a hole for the factory wiring grommet
• Includes necessary speaker harness adapter
TABLE OF CONTENTS
Dash Disassembly ..............................................2-6
Kit Assembly ..........................................................7
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• 8mm, 10mm, socket wrench
Attention! Let the vehicle sit with the key
out of the ignition for a few minutes before removing the factory radio. When testing the aftermarket equipment, ensure that all factory equipment is connected before cycling the key to ignition.
DASH DISASSEMBLY
1. Unclip and remove the panel below the steering column. Remove (2) Phillips screw exposed. (Figures A,B)
2. Unclip, unplug, and remove the climate control panel. (Figure C)
3. Remove (2) Phillips screws securing the radio trim panel, then unclip and remove. (Figure D)
4. Remove (1) Phillips screw securing the dash pad, then unclip and remove. (Figure E)
(Figure A)
(Figure D)
(Figure B)
(Figure E)
(Figure C)
2
1.800.221.0932 | MetraOnline.com
DASH DISASSEMBLY
5. Remove (8) Phillips screws securing the instrument panel on the left side, and airbag panel on the right side. (Figure F, G)
6. Unclip the steering column shroud then set aside. (Figure H)
Driver’s side speaker removal:
7. Open the driver’s door, then unclip
and remove the panel on the side of the dash. Remove (5) Phillips screws exposed. (Figure I)
8. Remove (5) Phillips screws securing the
(Figure F)
(Figure G)
(Figure H) (Figure J)
speaker panel, then unclip and remove. (Figure J)
(Figure I)
REV. 12/12/2019 INSTJP-1014
3
+ 5 hidden pages