Metra 99-8266BLHG Installation Guide
99-8266BLHG
INSTALLATION INSTRUCTIONS
Toyota Camry 2018-up*
*Visit MetraOnline.com for up-to-date vehicle specific applications.
KIT FEATURES
• ISO DIN radio provision with pocket
• ISO DDIN radio provision
• Tinted metallic finish
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets • C) Pocket • D) (4) #8 x 3/8” Phillips screws
A B C
®
Metra. The World’s Best Kits.
MetraOnline.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 8/3/18 INST99-8266BLHG
TABLE OF CONTENTS
Dash Disassembly ..................................................2
Kit Preparation .......................................................2
Kit Assembly
–ISO DIN radio provision with pocket ..................3
–ISO DDIN radio provision .....................................3
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: TBA
Antenna Adapter: 40-LX11
TOOLS REQUIRED
D
• Panel removal tool • Phillips screwdriver
• 10mm Socket wrench
CAUTION!
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
All accessories, switches, climate
DASH DISASSEMBLY KIT PREPARATION
1. Unclip and remove the dashboard trim
panel below the climate controls.
2. For models with a push button start:
Unclip the Start/Stop button trim panel
and set it to the side.
For models without a push button start:
Unclip and remove the trim panel to the
left of the radio/climate control panel.
3. Unclip and remove the lower dashboard
trim panel directly above the glovebox.
4. Unclip and remove the upper dashboard
trim panel with a/c vent.
5. Unclip the climate control panel and set
it to the side.
6. Remove (4) 10mm screws securing the
radio panel, then unplug and remove
the panel.
Continue to Kit Preparation
Please visit Metraonline.com for
Dash Disassembly illustrations.
1. Unclip and remove the passenger airbag
light assembly from the factory radio
panel, then attach the assembly to the
radio trim panel
.
2. Remove the panel clips from the factory
radio panel, then attach them onto the
radio trim panel
.
Continue to Kit Assembly
Please visit Metraonline.com for
Kit Preparation illustrations.
2
1.800.221.0932 | MetraOnline.com
Loading...