Metra 99-2003 Installation Guide
99-2003
APPLICATIONS
GM / SUZUKI MULTI KIT
99-2003
KIT FEATURES
• DIN Head Unit Provisions with Pocket
• ISO DIN Head Unit Provisions with Pocket
• Double DIN head unit provision
• Stacked ISO head unit provision
KIT COMPONENTS
A) Radio Housing w/ Pocket I B) ISO Trim Plate I C) DDIN Trimplate I D) DDIN Stacked ISO Brackets
E) DIN Spacer I F) ISO Snap In Brackets I G) Carriage Bolts I H) Kep Nuts
G
A
B
C
D
TOOLS REQUIRED:
Phillips Screwdriver I Utility Knife I Socket Wrench
E
F
H
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2004 METRA ELECTRONICS CORPORA
INST992003 - rev.08132004
TION
VEHICLE APPLICATION CONTENTS
BUICK
Century 1997-2004 3
Le Sabre 1995-2004 4,5
Park Avenue 1995-2004 4,5
Regal 1995-2004 3
Rendezvous 2002-2004 6
Riviera 1996-1999 7
Roadmaster 1995-1996 8
Skylark 1996-1998 9
CADILLAC
Escalade 2003-2004 10
Fleetwood/ Brooughham
1990-1996 11-13
CHEVROLET / GEO
Avalanche 2003-2004 10
Blazer 2002-2004 14
Cavalier 2000-2004 15
Express van 2001-2004 16,17
Impala 2000-2004 18
Malibu 2001-2003 19
Malibu Classic 2004 19
Metro 1992-2001 20
Monte Carlo 2000-2004 21
S-10 2002-2004 14
Silverado 2003-2004 10
Suburban 2003-2004 10
Tahoe 2003-2004 10
Tracker 1992-2004 22
Trailblazer 2002-2004 23
Venture 2000-2004 24,25
GMC
Envoy 2002-2004 28
Savanna 2001-2004 16,17
Sierra 2003-2004 10
Sonoma 2002-2004 14
Yukon/Denali/XL 2003-2004 10
2
HUMMER
H2 2003-2004 26,27
ISUZU
Ascender 2003-2004 28
OLDSMOBILE
Achieva 1996-1998 29
Alero 1999-2004 30
Aurora 1995-2003 31
Bravada 1998-01 14
Bravada 2002-04 28
Cutlass 1997-1999 32
Cutlass Supreme 1995-1997 32
Eighty-Eight 1994-1999 33
Intrigue 1998-2002 34
LSS 1996-1999 35
Ninety-Eight 1994-1996 33
Regency 1997-1998 35
Silhouette 2000-2004 24,25
PONTIAC
Aztec 2001-2004 36
Bonneville 2000-2004 37
Grand Am 2001-2004 38
Montana 2000-2004 24,25
Sunfire 2000-2004 39
SUZUKI
Aerio
Esteem
Sidekick 1992-1998 22
Swift
Vitara 1999-2004 22
2002
1995-2003
1995-2001
40
41
20
99-2003
BUICK • Century 1997-04 / Regal 1997 - 04
Disconnect the negative battery terminal to prevent an accidental short circuit.
1. Open both doors and remove end caps from both ends of dashboard.
2. Open glove box, then remove (1) 9/32" screw from panel above passenge
kick panel and remove.
3. Remove 9/32" screws from bottom left and right of ashtray assembly
and unclip and remove.
4. Unclip top edge of panel below steering column and let hang.
5. Remove (1) 9/32" screw from right side of instrument cluster and
radio trimpanel and remove entire panel from right to left.
6. Remove (3) 9/32" screws to remove radio.
7. See page 42 for all vehicle tab instructions.
DASH DISASSEMBLY
3
99-2003
BUICK • LeSabre 1995-99 / Park Avenue 1995-99
Disconnect the negative battery terminal to prevent an accidental short circuit.
1. Unsnap the climate control trim panel (from door to door) and remove (5) 9/32”
screws exposed.
2. Pop out the a/c vents and remove (1) Phillips screw exposed in each vent cavity.
3. Unclip the radio trim bezel and remove.
4. Remove the screws securing the factory head unit and disconnect the wiring.
5. See page 42 for all vehicle tab instructions.
4
DASH DISASSEMBLY
99-2003
BUICK • LeSabre 2000-04 / Park Avenue 2000-04
Disconnect the negative battery terminal to prevent an accidental short circuit.
1. Open drivers door and unsnap and remove dash end cap.
2. Remove (2) Phillips screws from underneath steering column cover.
3. Unsnap and remove steering column cover.
4. Unsnap and remove instrument panel.
5. Remove (2) 9/32" screws and remove radio.
6. See page 42 for all vehicle tab instructions.
DASH DISASSEMBLY
5
99-2003
BUICK • Rendezvous 2002-04
Disconnect the negative battery terminal to prevent an accidental short circuit.
1. Open center console and remove 2 screws at front of console opening.
2. Remove liners from cup holders and storage pocket next to cup holders,
then remove screws. Unsnap and remove panel.
3. Remove (2) screws from bottom of radio/climate control bezel, unclip
and remove.
4. Remove (3) 9/32" hex head screws to remove radio.
5. See page 42 for all vehicle tab instructions.
6
DASH DISASSEMBLY
99-2003
BUICK • Rivieria 1996-99
Disconnect the negative battery terminal to prevent an accidental short circuit.
1. Unsnap left side panel exposing (1) Phillips screw to remove.
2. Remove (1) Phillips screw and unsnap right side panel to expose
(1) Phillips screw beneath panel and remove.
3. Unsnap underside of overhanging dash to unsnap (6) plastic rivets and
remove panel.
4. Remove (5) hex head screws now exposed under overhang.
5. Unsnap bottom edge of trim bezel, then while holding overhang up,
unsnap and remove trim bezel by removing any necessary harnesses.
6. Remove (3) Phillips screw to remove climate control.
7. Remove (2) Phillips screws to remove rear support and (3) 9/32" hex
head screws to remove radio.
8. See page 42 for all vehicle tab instructions.
DASH DISASSEMBLY
7
99-2003
BUICK • Roadmaster 1995-96
Disconnect the negative battery terminal to prevent an accidental short circuit.
1. Unclip dash panel sides and remove.
2. Unclip panel below steering column and remove.
3. Unclip panel next to glove box on passenger side and remove.
4. Remove (2) 7mm screws above instrument cluster.
5. Set parking brake, turn car on, and move shifter to the lowest gear. Tilt steering
wheel down then unsnap entire instrument cluster/radio panel and remove.
6. Remove (3) 7mm screws to remove radio.
7. See page 42 for all vehicle tab instructions.
8
DASH DISASSEMBLY
99-2003
BUICK • Skylark 1996-98
Disconnect the negative battery terminal to prevent an accidental short circuit.
1. Remove (6) 9/32" screws inside glove box.
2. Under glove box and drivers knee bolster, remove (2) plastic panels by
turning (2) 1/4 turn fasteners per side.
3. Remove (4) 9/32" screws revealed. (2 per side).
4. Unsnap panel from driver's side to passenger's side.
5. Remove (3) 9/32" screws to remove radio.
6. See page 42 for all vehicle tab instructions.
DASH DISASSEMBLY
9
99-2003
CADILLAC • Escalade 2003-04
CHEVROLET • Avalanche 2003-04
Silverado 2003-04 / Suburban 2003-04
Tahoe 2003-04
GMC • Sierra 2003-04
Yukon / Denali / XL 2003-04
Disconnect the negative battery terminal to prevent an accidental short circuit.
1. Unsnap and remove dash bezel.
2. Remove (3) 9/32" screws and remove radio.
3. See page 42 for all vehicle tab instructions.
10
DASH DISASSEMBLY
99-2003
CADILLAC • Fleetwood 1990-96 / Fleetwood Brougham 1990-96
Disconnect the negative battery terminal to prevent an accidental short circuit.
1. Carefully unsnap trim panel above a/c controls.
2. Remove (2) 7mm screws at the top of the radio/air conditioning bezel, then
unclip panel and remove.
3. Remove (4) 7mm screws that hold the radio in, slide radio out, unplug the
radio harnesses and remove radio.
4. See page 42 for all vehicle tab instructions.
DASH DISASSEMBLY
Continued on page 12 and 13.
11
99-2003
12
DASH DISASSEMBLY
1) Remove (4) 10mm nuts, (2) on top of the radio and (2) on the bottom of the
radio, that hold the factory mounting brackets on.
99-2003
DASH DISASSEMBLY
2) Using carriage bolts and Keps nuts supplied, mount the factory brackets
to the radio housing with the pocket, keeping in mind which bracket is top
and which one is bottom.
13
99-2003
CHEVROLET • Blazer 2002-04 / S-10 2002-04
GMC • Sonoma 2000-04
OLDSMOBILE • Bravada 1998-01
Disconnect the negative battery terminal to prevent an accidental short circuit.
1. Remove (2) 9/32" hex-head screws from the knee bolster.
2. Pull down on the bolster and remove 9/32" screws exposed on the base of
the dash trim bezel.
3. Remove (1) Phillips screw above the instrument cluster.
4. Unclip the dash trim bezel and remove.
5. Unclip the dash trim bezel and remove.
6. See page 42 for all vehicle tab instructions.
14
DASH DISASSEMBLY
99-2003
CHEVROLET • Cavalier 2000-04
Disconnect the negative battery terminal to prevent an accidental short circuit.
1. Open driver door and remove fuse panel on the end of dash.
2. Open passenger door and remove panel on end of dash.
3. Remove (1) Phillips screw from each side exposed.
4. Remove (3) screws from top of glove box liner.
5. Remove (2) screws from the top-left corner of the glove box cavity.
6. Remove (1) Phillips screw from the defroster duct.
7. Remove the duct work and (1) Phillips screw exposed.
8. Remove the dash pad and (3) Phillips screws exposed at the top of the
radio trim bezel.
9. See page 42 for all vehicle tab instructions.
DASH DISASSEMBLY
15