Metra 95-8160G Installation Manual
Installation instructions for 95-8160G
Lexus LS430 2001-2006 (without factory NAV)
95-8160G
KIT FEATURES
• Double DIN radio provision
• Painted gray to match factory color and finish
KIT COMPONENTS
• A) Radio housing • B) Brackets • C) Panel clip brackets (2) • D) Panel clip bracket screws (4) #4 x 3/8”
• E) Panel clips (2) • F) (4) #8 x 3/8” truss-head Phillips screws
A
B C D
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • TYTO-01 Axxess Interface
REV. 12/15/2014 INST95-8160G
Antenna Adapter: • 40-LX10 antenna adapter and 44-EC204 antenna extension
METRA. The World’s best kits.
™
E
F
metraonline.com1-800-221-0932
Table of Contents
Dash Disassembly
– Lexus LS430 2001-2006 ..................................... 2
Kit Assembly
– Double DIN radio provision ................................... 3
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• Socket wrench
CAUTION: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
NOTE: Refer to the instructions included with the
aftermarket radio.
© COPYRIGHT 2014 METRA ELECTRONICS CORPORATION
1. Remove the heated seat switch
panel. (Figure A)
2.
Remove the three screws below
the tray assembly. Unclip and
remove try assembly. (Figure B)
3.
Remove two 10mm bolts securing
the factory radio. (Figure C)
Continue to kit assembly
95-8160G
Dash Disassembly
(Figure A) (Figure B) (Figure C)
2
Double DIN radio provision
1.
Attach the brackets to the radio
housing trim panel using the (4)
#8 x 3/8” screws supplied.
(Figure A)
2.
Slide the radio into the bracket/
radio housing assembly and secure
to the assembly using the screws
supplied with the radio. (Figure B)
3.
Mount the two panel clip brackets
to the radio housing using the
supplied (4) #4 x 3/8” screws.
(Figure C)
4.
Attach the (2) white plastic panel
clips to the panel clip brackets.
(Figure C)
95-8160G
Kit Assembly
5.
Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
6.
Note: the factory antenna
connection is located at the
tuner brain on the passenger
side rear of the trunk and will
(Figure A) (Figure C)
need to be routed through the
vehicle to connect with the
aftermarket radio.
7.
Reassemble dash in reverse order
of disassembly.
(Figure B)
3
Loading...