Metra 95-7638 INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
95-7638
Nissan Sentra 2020-Up
Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle
specific applications
KIT FEATURES
• ISO DDIN radio provision †
• Pioneer modular DDIN radio provision †
• Painted with a gloss black face, silver trim, and a textured housing.
† This kit can only be used with an ISO DDIN radio with an “L” shaped chassis design, with the radio
chassis at the bottom of the screen. As of this writing, only the Alpine INE-W967HD (discontinued,
replaced by INE-W977HD), iLX-107, and iLX-207 have this design. Also, The Pioneer modular radios,
DMH-C2550NEX and DMH-C2500NEX, can also be used with the included adapter brackets.
KIT COMPONENTS
• A) Radio housing (front) • B) Radio housing (rear) • C) Radio trim panel • D) Radio brackets • E) Pioneer adapter brackets
• F) #4 x 3/8” Phillips screws (4) • G) #6 x 3/8” Phillips screws (4) • H) Panel clips (3)
A B C
®
Metra. The World’s Best Kits.
F G
MetraOnline.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION REV. 9/28/20 INST95-7638
D E
H
TABLE OF CONTENTS
Dash Disassembly ..................................................2
Kit Assembly
– ISO DDIN radio provision ................................ 3-4
– Pioneer modular DDIN radio provision.........5-6
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: 70-7552
Antenna Adapter: 40-NI12
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• 10mm socket wrench
Attention! Let the vehicle sit with the key
out of the ignition for a few minutes before
removing the factory radio. When testing the
aftermarket equipment, ensure that all factory
equipment is connected before cycling the
key to ignition.
1. Unclip and remove the trim panel
behind the radio. There are (4) clips
securing this panel to the dash. Use
caution as the front of the trim panel
can easily be damaged. (Figure A)
Note: Dash vents may vary depending
on Nissan model.
2. Remove (4) 10mm screws securing the
radio. Take note that the lower radio
brackets are angled inward, hiding the
bottom (2) screws from being easily
seen. Slide the radio out, then unplug
and remove the radio. (Figure B)
Continue to Kit Assembly
DASH DISASSEMBLY
(Figure A) (Figure B)
2
386.257.1187 | MetraOnline.com
ISO DDIN radio provision
1. Attach (3) panel clips provided onto the
radio housing (front). (Figure A)
2. Snap the radio housing (front) to the
radio housing (rear), then secure using
(4) #4 x 3/8” Phillips screws provided
(Figure B)
3. Secure the radio brackets to the radio
housing using (4) #6 x 3/8” Phillips
screws provided. (Figure C)
Continued on the next page
KIT ASSEMBLY
(Figure A) (Figure B) (Figure C)
REV. 9/28/2020 INST95-7638
3
Loading...