Metra 108-FD7B Installation Instructions
INSTALLATION INSTRUCTIONS
Patent Pending
108-FD7B
Ford F-250/350/450/550 XL
*Visit MetraOnline.com for up-to-date vehicle specific applications.
(w/o color screen)
2017-up*
KIT FEATURES
• Designed specifically for the Pioneer DMH-C5500NEX 8-inch radio
• Painted scratch-resistant matte black to match the
factory color and finish
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets • C) Switch housing • D) #8 x 3/8” Phillips screws (3) • E) #6 x 3/8” Phillips screws (4) • F) Panel clips (6)
A B C D E E
®
Metra. The World’s Best Kits.
MetraOnline.com © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION REV. 11/1/19 INST108-FD7B
F
TABLE OF CONTENTS
Dash Disassembly ..................................................2
Kit Preparation .......................................................2
Kit Assembly ..........................................................3
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: XSVI-5524-NAV
Antenna Adapter: 40-EU10
Steering wheel control interface: ASWC-1
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• 9/32” socket wrench • Torx screwdriver
Attention! Let the vehicle sit with the key
out of the ignition for a few minutes before
removing the factory radio. When testing the
aftermarket equipment, ensure that all factory
equipment is connected before cycling the
key to ignition.
DASH DISASSEMBLY KIT PREPARATION
1. Remove the storage mat in the pocket
above the climate-control/radio trim
panel, then remove (2) 9/32” screws
exposed. (Figure A)
2. Unclip and remove the pocket, then
remove (2) 9/32” screws exposed.
(Figure B)
3. Unclip, unplug, and remove the climatecontrol/radio trim panel.
Continue to Kit Preparation
From the factory climate-control/radio
trim panel:
1.
Remove (4) Torx screws securing the climate
control panel, then remove.
2.
Unclip and remove the switches.
3.
Unclip and remove the LINE IN jack.
4.
Unclip and remove the power port assembly.
(Figure A)
(Figure A)
(Figure A)
.
(Figure A)
To the 108-FD7B climate-control/radio trim panel:
5.
(Figure A) (Figure A)
Secure the climate control panel to the panel using
(4) #6 x 3/8” Phillips screws provided.
6.
Trim the bottom tab from the switch housing
(Figure B)
(see inset). Secure the switch housing to the
panel using (3) #8 x 3/8” Phillips pan-head screws
provided.
(Figure B)
7.
Snap the factory switches into the switch housing.
(Figure B)
8.
(Figure B)
Snap the LINE IN jack to the panel.
9.
Snap the power port assembly to
the panel.
(Figure B)
10.
Attach (6) panel clips to the panel.
Continue to Kit Assembly
(Figure B)
Remove
shaded area
(Figure B)
2
1.800.221.0932 | MetraOnline.com
Loading...