7 05/2007 Rev. 1.0
Cleaning of the appliance and accessories
Clean the outside of the appliance with a clean, damp cloth, if necessary using
a mild (non-abrasiv e) cleaning agent.
Do not use an abrasive, as this will leave scratches and dull patches.
The glass jugs and the basket filter can be washed normally and rinsed clean.
Please note, however, that it is inadvisable to clean the basket filter in an industrial
dish washer as its light ness m ay c ause i t t o float and sustai n damage.
The coffee deposit in the coffee jugs and the filter can be cleaned with Animo coffee fur remover.
7.1 DESCALING
The machine can leav e lim e deposits during use. The machine should be descaled minimum once a month in order
to ensure that it functi ons efficiently.
1. Befor e descaling the appliance, carefully read the instr uc tions for use on the scale remov er.
We advise you to use the tried and t ested A nim o scale remover.
2. Dissolve one 50 gr am sachet of A nim o scale remover in 1 litre of warm water (approx. 60- 70˚C).
3. Slide an empt y basket fi lter into the filter holder and place an empt y jug under it.
4. Carefully pour the solution into the reservoir and switch on t he appliance (fig. 3A / 4A).
The solution will now run thr ough the heating system and discharge into the jug.
Leave the lid of the reservoir open!
5. Switch off t he appliance using switch (fig. 3A / 4A) aft er 1 minut e.
6. Now wait about 2 minut es. The solution will react with the deposit in the heating system.
7. After the waiti ng time, switch the appliance back on and all ow the rest of the solution to run through the system.
8. Wash away the solution in the jug until the filter has fi nished dripping.
9. After descaling the appliance, flush the system by following the coffee brewing proc edur e tree times but without
using filter paper or c offee. Remember to empty the jug in the meantime.
10. Switch off the appliance and thoroughly clean the basket filter and the jug
11. T he appliance is now ready for use.
8. TRANSPORT
The following proc edur e shoul d be followed when the applianc e is tr ansport ed:
1. Switch off the machine (fig. 3C & 4C) and remove the plug from the wall socket.
2. Remove the jugs and the basket filter.
3. Empty the machine, by turning it upside down above the sink, so that the remaining
water runs out throug h the spray head (attention: the water can still be hot!)
4. Wipe the machine dry, and replace all the components that have been removed.
5. The machine is now ready for transport.
6. When it is relocated, the procedures of “Installation”, should be followed.