Methven Tahi Satinjet Shower Kit User Manual

ADJUSTMENT

Shelf adjustment

UN-LOCK

LOCK

CLEANING

Water contains lime which remains on the surface after
the water has evaporated. These lime deposits can be
prevented from forming by wiping immediately after use.

Handset holder tension adjustment

Located at the
back of slider

Thumb screw

Adjust the tension on the handset holder by rotating the
thumb screw.

To clean the chrome-plated surfaces use a soft cloth,
soap and warm water. Never use cleaning agents that
contain a corrosive acid or a scouring additive.

TAHI SATINJET SHOWER KIT

INSTALLATION GUIDE

TECHNICAL SPECIFICATIONS

Operating Pressure:

Min 1.5 bar, Max 5 bar.
If supply exceeds 5 bar, a pressure
limiting valve must be installed.

Operating Temperature:

Max 70°C.

Notes:

After installation all connections ●
must be checked for leaks.
All installations must be carried ●
out in compliance with relevant
water regulations.

Clean filter washer
periodically.

Do not use any
sharp objects to
clean nozzles.

Methven warrants this product against manufacturing defects and that it is suitable for use
under the operating conditions specified in this instruction sheet.

For your warranty please refer to www.methven.com or call Customer Service

New Zealand

0800 804 222

Australia

1300 638 483

UK

0800 195 1602

Issue A435023

A

Rail brackets

Bracket caps

1. 2. 3.

B

Mounting bosses

Rail

Handset holder

Handset

Hose elbow

Hose

Fastening Zone
– load-bearing
support required

Approx max usable

height above screw - 70mm

Fastening Zone
– load-bearing
support required

NOTE - Elbow and rail height at installers discretion
to comply with local standards.

1082mm

DESIRED HEIGHT

Mark top screw hole. Mark plumb-line
to floor and then mark lower screw
hole 1082mm from upper mark. Drill
holes for screws.

Seal holes. Drive screws through
mounting bosses into the load­bearing support on wall (and wall
plug if appropriate).

4. 6.5.

Bracket caps

Ensure bracket caps are fitted as
shown and push brackets into rail top
and bottom.

Push rail assembly firmly onto
mounting bosses.

7.

Release lever and slide shelf (if
included) and handset holder on to
top of rail.

Tighten grub screws with provided
hex key.

OPTIONAL

Double shelf

Single shelf

Attach hose & insert trays. Adjust
shelf position & handset tension, see
over leaf for instructions.