Methven 02-9358 Installation Guide

Technical Specifications

Minimalist Spring Pull Down

Inlet Connections: All 1/2’ BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.

Hose Requirements for mixers

The maximum working pressure of the ceramic cartridge is 1000kPa.
Do not hydrostatic test the installation with this mixer installed. Damage to
the ceramic cartridge may occur.

Sink Mixer with Twin Action Spray

02-9358

Illustration may not reflect actual product shape.

Installation Guide

“In situ” testing

The maximum working pressure of the ceramic cartridge is 1000kPa. Do not
hydrostatic test the installation with this mixer installed. Damage to the ceramic
cartridge may occur, voiding our warranty.

APR 2017 MA433094

Methven Australia Pty Ltd

ABN 15 104 813 390

Melbourne, Australia

www.methven.com

IMPORTANT

Please read all of the instructions before installation

Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.

www.methven.com

WMKA21870

Installation

NO NAME QTY

1 Mixer body 1
2 Chrome base ring 1
3 Rubber washer 2
4 Plasc spacer 1
5 Brass lock nut 1
6 Cold supply line 1
7 Hot supply line 1
8 Spray nozzle 1
9 Washer 1

1. Suitable diameter hole size through the bench top is 35-38mm. Ensure the thickness of the
bench top does not exceed 30mm.

2. Remove the rubber seal washers brass lock nut and plastic spacer.

3. Fit hot and cold supply hoses into mixer body

4. Place the mixer body and hoses through the hole cut in the bench top. (NB: The hoses will
need to be placed through the holes one at a time).

5. Fit chrome base ring to mixer body.

We recommend that this product is installed by a licensed plumber.

DRAWING A

6. Secure the faucet using the washer spacers and brass lock nut against the of the
bench.

7. Flush pipework thoroughly.

8. Connect the hoses to their respective water supplies (see over page). Two rubber
washers are provided for the flexible hose supply conections. Machined nipple ends
are required to ensure a seal to the flexible hose nuts and the rubber washers.

THE METHVEN GUARANTEE

The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia