Kaha Wall Spout
Kaha Wall Spout
Bath 01-7409
Basin 01-7430
Illustration may not reflect actual product shape.
Installation Guide
Bath 01-7409
Basin 01-7430
Illustration may not reflect actual product shape.
Installation Guide
IMPORTANT
Please read all of the instructions before installation
Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.
www.methven.com www.methven.com
SPEC 001
Applies to Basin Spout only
IMPORTANT
Please read all of the instructions before installation
Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.
SPEC 001
Applies to Basin Spout only
Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
Technical Specifications
Inlet Connections: All 1/2" BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.
Bath Spout
Faceplate
½” BSP
(Not Supplied)
Technical Specifications
Inlet Connections: All 1/2" BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.
Bath Spout
½” BSP
(Not Supplied)
Faceplate
M5 Grubscrew
2.5mm Hex Key
NOTE: Maximum hole diameter through wall for ½” BSP tube is 22mm.
MAY 2011 MA017409
Inlet Connector
THE METHVEN GUARANTEE
The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia
We recommend that this product is installed by a licensed plumber.
M5 Grubscrew
2.5mm Hex Key
NOTE: Maximum hole diameter through wall for ½” BSP tube is 22mm.
MAY 2011 MA017409
Inlet Connector
THE METHVEN GUARANTEE
The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia
We recommend that this product is installed by a licensed plumber.
Loading...