Methven 01-7300 Installation Guide

Stream shaper

O-ring

Mounting stud

Mounting gasket
Mounting plate

Mounting nut

Kaha Sink Mixer

01-7300

Flexible inlet hose:
cold
hot

“In situ” testing

The maximum working pressure of the ceramic cartridge is 1000kPa. Do not
hydrostatic test the installation with this mixer installed. Damage to the ceramic
cartridge may occur, voiding our warranty.

MAY 2011 MA017300

Methven Australia Pty Ltd

ABN 15 104 813 390

Melbourne, Australia

www.methven.com

Illustration may not reflect actual product shape.

Installation Guide

IMPORTANT

Please read all of the instructions before installation

Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.

www.methven.com

SPEC 001

Technical Specifications Installation

Refer to diagram at right.

Inlet Connections: All ½" BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.

Hose Requirements for mixers

The maximum working pressure of the ceramic cartridge is 1000kPa.
Do not hydrostatic test the installation with this mixer installed. Damage to
the ceramic cartridge may occur.

1. A single 35mm diameter hole is required in the mounting surface. The mounting
surface can be a maximum of 40mm thick.

2. Screw the threaded studs into the base of the mixer. Insert the O ring into the
groove in the bottom of the base ring and fit the base ring to the bottom of the
mixer.

3. Insert the flexible hoses through the hole in the mounting surface (from the
underside) and screw them into the base of the mixer.

4. Feed the threaded studs through the hole in the mounting surface. Fit the
mounting gasket and mounting plate onto the threaded rods.

5. Tighten the mounting nuts to secure the mixer in place.

6. Connect the flexible hoses to the hot and cold supplies (hot on the left, cold on
the right). It is a condition of our warranty that the filter washers as supplied be
fitted at this connection.

DO NOT CRUSH
HOSE OR SWAGED ENDS

20mm

R35mm Min

DO NOT STRETCH OR TWIST HOSES

CORRECT

INCORRECT

We recommend that this product is installed by a licensed plumber.

THE METHVEN GUARANTEE

The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia