Methven 01-5306 Installation Guide

MAR 2008 MA015306

Kiri Sink Mixer

01-5306

Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.

IMPORTANT

Please read all of the instructions before installation

Installation Guide

Ø 35mm
(1

3/8

”)

Cold

Hot

Max 40mm
(1

9/16

”)

www.methvenaustralia.com.au

Methven Australia Pty Ltd

ABN 15 104 813 390

Melbourne, Australia

www.methvenaustralia.com.au

Technical Specifications

THE METHVEN GUARANTEE
The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methvenaustralia.com.au

THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia

We recommend that this product is installed by a licensed plumber.

Installation

Inlet Connections: All 1/2’ BSP

Operating Pressure: 150kPa - 500kPa

Operating Temperatures: Recommended hot water supply 50°C,

maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.

Hose Requirements for mixers

The maximum working pressure of the ceramic cartridge is 1000kPa. Do not
hydrostatic test the installation with this mixer installed. Damage to the ceramic
cartridge may occur.

Refer to diagram at right.

1. A single 35mm diameter hole is required in the
mounting surface. The mounting surface can be a
maximum of 40mm thick.

2. Screw the threaded studs into the base of the mixer.

Insert the O ring into the groove in the bottom of the
base ring and fit the base ring to the bottom of the
mixer.

3. Insert the flexible hoses through the hole in the
mounting surface (from the underside) and screw
them into the base of the mixer.

4. Feed the threaded studs through the hole in the
mounting surface. Fit the mounting gasket and
mounting plate onto the threaded rods.

5. Tighten the mounting nuts to secure the mixer in
place.

6. Connect the flexible hoses to the hot and cold

supplies (hot on the left, cold on the right).