Methven 01-2381 Installation Guide

Ceramic Cartridge Adjustment

Do not remove the ceramic cartridge from the body assembly while carrying
out the following adjustments. Note, the cartridge is factory set for maximum
temperature

Minimalist Hi-Rise Sink Mixer

Gooseneck 01-2350

Square Neck 01-2381

Remove half-dome
(if attached)

Flow limiting adjustment

1.5mm
Allen key

Mix temperature limiting adjustment

Illustration may not reflect actual product shape.

Installation Guide

IMPORTANT

Please read all of the instructions before installation

Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.

WMKA 21005

MAY 2009 MA433097

Methven Australia Pty Ltd

ABN 15 104 813 390

Melbourne, Australia

www.methven.com

www.methven.com

Technical Specifications Installation

Refer to diagram at right and back.

Inlet Connections: All 1/2’ BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.

Hose Requirements for mixers

The maximum working pressure of the ceramic cartridge is 1000kPa.
Do not hydrostatic test the installation with this mixer installed. Damage to
the ceramic cartridge may occur.

1. A single 38mm diameter hole is required in the
mounting surface. The mounting surface can be a
maximum of 40mm thick.

2. Screw the threaded studs into the base of the mixer.

Insert the O ring into the groove in the bottom of
the base ring and fit the base ring to the bottom of
the mixer.

3. Insert the flexible hoses through the hole in the
mounting surface (from the underside) and screw
them into the base of the mixer.

4. Feed the threaded studs through the hole in the
mounting surface. Fit the mounting gasket and
mounting plate onto the threaded rods.

5. Tighten the mounting nuts to secure the mixer in
place.

6. Connect the flexible hoses to the hot and cold
supplies (hot on the left,
cold on the right).

“In situ” testing

The maximum working pressure of the ceramic cartridge is 1000kPa. Do not
hydrostatic test the installation with this mixer installed. Damage to the ceramic
cartridge may occur, voiding our warranty.

We recommend that this product is installed by a licensed plumber.

THE METHVEN GUARANTEE

The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia