Metalac INOX MC8N, INOX MC8P Installation Manual
INSTRUCTIONS FOR INSTALLATION, USE AND
CARE OF WATER HEATERS
INOX MC 8 N , MC 8 P
2
CONTENTS
TECHNICAL INFORMATION.............................................................3
INSTALLATION .................................................................................3
CONNECTION TO WATER SUPPLY....................................................5
STEPS FOR CONNECTION TO WATER SUPPLY.................................6
CONNECTION TO POWER SUPPLY...................................................7
USE AND MAINTENACE...................................................................7
WASTE DISPOSAL.............................................................................8
3
TECHNICAL INFORMATION
Low capacity electrical water heaters are designed as open
system without pressure. Water heaters are made according to valid
standards and tested and certified by authorized laboratory.
The appliance is not meant for persons (including children)
of reduced psychophysical abilities, unless under supervision of persons responsable for their safety, i.e. for persons not skilled for use
of the appliance. Improper use of the appliance, especially from the
side of children, should be prevented. Product technical characteristics are given on the sticker „Table with Characteristics“ between connection pipes.
Picture 1 shows the water heater with all components.
N – wall/ high installation P – low installatiuon
INSTALLATION
Only authorized persons are allowed to do installation / connection of low capacity water heaters to water and power supplies.
Installation to be carried out by the scheme at specific place,
as near as possible to the point of use. Installation in the environement with possible low temperatures to be avoided (water freeezing
could cause the tank breakage)
Pict. 1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
1. - Front cover
2. - Back
3. - Insulation
4. - Tank
5. - Mg-anode
6. - Heater
7. - Flange
8. - Seal
9. - Thermoregulator
10. - Thermoregulator button
11. - Counter-flange
12. - Thermal cut
13. - Water inlet/outlet
14. - Terminal strip
Loading...