Page 1
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER
WARNING:
BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. This fixture matched 15 × G9/Bi-pin Socket 25 - Watt maximum light bulbs
or LED equivalent bulbs (not included).
2. The small hole in the lampshade is used for heat dissipation to prevent the
lampshade from shattering due to high bulb temperature.
3. To enjoy the product's full dimming capabilities, you will need a dimmable bulb
and a dimmer switch. (dimmer switch and bulbs are not included)
Page 2
Installation Steps
Turn off the power at fuse or circult box
We recommend dividing the 15 white wires from the pole of the fixture into two groups, t
1-3.
number of 7 as group A and the number of 8 as group B. The 15 black wires are grouping
way as the white wires. [see below image]
Next, connect the two groups (Group A and Group B) of white light pole wires using the
wire provided; finally, connect the white light pole wire of Group B to the white main wire
The black wires are connecting in the same way as the white wires. [see below image]
4-5. Carefully put the wires back into the cylindrical box and then tighten the screw.
6-7. Select the appropriate hanging height, then pass the boom wire through the canopy and tighten
the boom.
8. Fasten the hanging plate on the ceiling with
9. Pull out the source wires from the canopy. Make wire connections using wire nuts as follows:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw, and
then connect it to the house grounding wire with a wire nut.
10-11. Attach the canopy onto the outlet and tighten it with two ball nuts.
screws.
he
in the same
short white
of the boom.
12-13 Install the bulb (
not included) and attach the lampshade.
Turn on the power at fuse or circuit box
Loading...