Page 1
CEILING/WALL
TRACK LIGHTING
“INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS”
“READ ALL INSTRUCTIONS”
“IMPORTANT SAFETY
INSTRUCTIONS”
!
“SAVE THESE INSTRUCTIONS”
TOOLS AND MATERIALS REQUIRED:
Wiring supplies
as required by
Phillips
Screwdriver
Pliers
Wire Cutters
Wrench
the Canadian
Electrical Code
and/or the
Quebec
Electrical code
SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3.
FIRMLY ATTACH THE FIXTURE GROUND WIRE (BARE COPPER) TO THE MOUNTING BRACKET WITH
THE GROUND SCREW (BY WRAPPING AROUND THE GROUND SCREW) AND THEN CONNECT IT TO
THE HOUSE SUPPLY GROUND WIRE WITH A WIRE NUT.
INSTALLATION: NOTE: Product May Not Look Exactly As Shown In Figures.
STYLE#1
STYLE#2
STYLE#3
Nipple
Hex Nut
(not included)
STYLE#1
STYLE#2
Studs
Studs
Outlet
Box Screws
Mounting
Bracket
“A”
“B”
“B”
Outlet
Box
STYLE#3
1. NOTE: Refer to the
mounting bracket style that
matches the bracket that is
included with your fixture.
Style#1 (Non-Threaded holes)
Loosen hex nut “A” and “B”.
Adjust stud so it clears the
fixture once assembled. Hold in
place with “A” and lock in place
with “B”.
Style#2 (Threaded holes)
Loosen “B”. Adjust stud to
desired length and lock in place
with “B”.
Style#3 (Nipple)
Attach nipple to mounting
bracket and adjust until it will
clear fixture when assembled.
Lock in place using the hex nut.
2. Mount the mounting
bracket to outlet box using
outlet box screws (not
included). Make sure the studs
or nipple on the mounting
bracket are facing out from the
outlet box.
House supply
Ground wire
Fixture
Ground wire
Fixture
Star
Washer
Fixture
Socket
Black
White
Stud
Or
Nipple
Cap
Nut
“Pop Off”
Head Or
Glass
3. Firmly attach the fixture
ground wire (bare copper) to
the mounting bracket with the
ground screw (by wrapping
around the ground screw) and
then connect it to the house
supply ground wire with a wire
nut. Connect the black wire (or
wire with marking) from the
fixture to the black wire in the
electrical box and connect the
white wire from the fixture to
the white wire in the electrical
box.
4. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
outlet box making sure no bare
wire (on the black and white) is
visible at the wire nuts. Install
the light fixture to the wall by
aligning the hole(s) in the
fixture with the studs or nipple
on the mounting bracket.
Secure in place with cap nut(s)
and star washer (s).
5. Snap “pop off” head or
glass onto fixture (push, or
push and turn (it depends on
the style of your fixture)). Install
proper bulb type and wattage
(not included).
Loading...