Page 1
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Green Grounding Screw
Mounting Plate
House Grounding Wire
Outlet Box
Long Set Screw
Mounting Screw
Fixture Wire
Wire Nut
Back Plate
Fixture Grounding Wire
Short Set Screw
Cylinder
Bulb Type A Max.60W
(not included)
1. Attach the mounting plate to the outlet box by using two mounting screws.
2. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
3. Attach the back plate to the mounting plate by aligning holes, secure the long set screw from
the top hole of the back plate into the hole in the top side of the mounting plate. Then secure
the short set screw from the bottom hole of the back plate to the bottom side of the mounting
plate.
CAUTION: With silicone caulking compound, caulk completely around where the back plate
meets with the wall surface to prevent water from seeping into the outlet box.
4. Install a bulb (not included). See relamping label at socket area or packaging for maximum
allowed wattage.
5. Turn on the power at the main fuse or circuit breaker box.
Loading...