Page 1
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Mounting Strap (A)
Finial (H)
Mounting Screw (B)
Decorative Cup (I)
Wire Connector (C)
Hex Nut (J)
Threaded Pipe (K)
Installation Steps
Turn off the power at fuse or circuit box
1. Attach two fixture mounting screws to the mounting
strap, and then secure it with two lock nuts. Adjust the
length of the fixture mounting screws if necessary.
2. Attach the mounting strap to the outlet box using two
mounting screws.
3. Pull out the source wires from the outlet box. Make
wire connections using wire connectors as follows:
---Connect the black wire from the fixture to the black
wire from the power source.
---Connect the white wire from the fixture to the white
wire from the power source.
---Attach the fixture grounding wire to the mounting
strap with the green grounding screw, and then
connect it to the house grounding wire with a wire
connector.
Carefully put the wires back into the outlet box.
4. Attach the canopy to the mounting strap by inserting
the fixture mounting screws, and then secure it with
two ball nuts.
Fixture Mounting
Screw(D)
Washer (L)
Bulb Type A Max.60W
(not included)
Green Grounding
Screw (E)
Rubber Pad(M)
Lock Nut (F)
Outlet Box
House Grounding Wire
wire connector (C)
Fixture Mounting Screw (D)
Mounting Strap(A)
Lock Nut(F)
Green Grounding Screw(E)
Mounting Screw(B)
Canopy
Ball Nut (G)
Ball Nut (G)
Metal Pad (N)
Socket
Coupling
Washer (L)
Threaded Pipe (K)
Fixture
5. Screw the threaded pipe into the coupling, then secure
it with a washer and hex nut.
Note: Depth of threaded pipe may need to be adjusted
to properly fit glass shade,decorative cup and finial.
6. Install 2 x 60W max medium base bulbs (not included)
to the sockets.
7. Slip the glass shade through the threaded pipe and upward the
ceiling pan. Then tighten them with a rubber pad, metal pad and hex nut.
Caution: Do not over tighten, breakage of glass shade could be occurred.
Glass Shade
Rubber Pad(M)
Metal Pad (N)
Hex Nut (J)
Decorative Cup (I)
Finial (H)
Page 2
8. Slip the decorative cup up through the threaded pipe, secure it with a finial.
Turn on the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Strap (A)
Mounting Screw (B) Wire Connector (C)
Threaded Pipe (K)Hex Nut (J)Decorative Cup (I)Finial (H)
Mounting Hardware (1SET)
Fixture Mounting
Screw(D)
Glass Shade
Green Grounding
Screw (E)
Washer (L)
Lock Nut (F)
Rubber Pad(M)
Ball Nut (G)
Metal Pad (N)
A: 15"
B:8"
Loading...