Page 1
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJ ON CTEUR.
45492 45493 49292 49293 45982 45983
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installation.
3. Slide the electrical wires through the pipe(K)/(J)/(I). Raise the pipe(K) to
the top coupling of lamp body(L), by turning it clockwise until tight. Raise
the pipe(J)/(I) onto the end of pipe thread, by turning it clockwise until tight.
Raise the canopy(G) to the end of pipe(I), lock it securely with the lock
washer and hex nut(F).
4. End of pipe thread screw(C) into single bar (D), place lock washer (B) over
the end of thread protruding through single bar and lock it securely with the
hex nut (A). Take this single bar assembly to junction box with junction box
screws (E), tighten screws securely with screwdriver. The side of the
single bar marked "GND" must face to out. The junction box is not
included.
5. While holding the fixture body towards the ceiling, connect the electrical
wires as Shown in Fig.2, making sure that all wire nuts are secured. You
may have to wrap the connections with electrical tape. If your outlet has a
ground wire (green or bare copper), connect the fixture ground wire to it.
Otherwise connect fixture’s ground wire directly to the Single bar with the
green screw provided. After wires are connected, tuck them carefully
inside the Junction Box.
6. Raise the fixture body onto the Junction box, aligning screw on single bar
with mounting hole in canopy and lock it securely with the finial(H).
7. Raise the shade(M) to the lamp holder, lock it securely with the check
ring(N).
8. Install the light bulbs(Not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
Your installation is now complete. Return power to the
junction box and test the fixture.
FIG.2FIG.1
FIXTURE
WIRES
D
Black or
Smooth
F
G
H
HOUSE
WIRES
Black(Hot)
FIXTURE
J
WIRES
White or
Ribbed
K
L
HOUSE
WIRES
White
(Neutral)
FIXTURE
M
WIRES
Bare
Copper
(Ground)
N
HOUSE
WIRES
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at: 800-761-8056
Green or Bare
Copper(Ground)
Or visit us online at: WWW.LIVEXLIGHTING.COM
©COPYRIGHT ALL RIGHTS RESERVED.LIVEX LIGHTING,INC. DOC20191045492
Loading...