Page 1
Bar Stool
IMPORTANT
Carefully remove all the parts from the carton and
place them individually on a soft cloth to prevent
scratches or other damage.
Carefully and strictly follow these assembly instructions
to ensure a completed product as designed.
Do not use power tools above 8 volts to assemble.
Part List
A.
Seat
1 pc.
E.
Side Stretcher
1 pc.
Hardware List
Hex Wrench
1 pc.
B.
Leg
1 pc.
F.
Side Stretcher
1 pc.
M4x40
Wood Screw
6 pcs. (+1 extra)
C.
Leg
1 pc.
G.
Front Stretcher
1 pc.
M8x40
Head Cap Bolt (short)
3 pcs. (+1 extra)
D.
Back Frame
1 pc.
M8x50
Head Cap Bolt
4 pcs. (+1 extra)
Small Hex Wrench
1 pc.
Spring Washer
11 pcs. (+1 extra)
Tool(s) required for assembly: Phillips screwdriver
Flat Washer
11 pcs. (+1 extra)
M8x80
Head Cap Bolt (long)
4 pcs. (+1 extra)
Page 2
Assembly Instructions 2/3
IMPORTANT
Use a soft cloth between these parts and the floor.
Do not use power tools above 8 volts to assemble.
Do not tighten all the bolts until each part is properly assembled.
Keep Hex Wrench as the bolts may need to be tightened in the future.
Wood Screw
Arrow label at front
F
G
C
Head Cap Bolt
Spring Washer
Flat Washer
B
A
STEP 1
Attach Legs (B) and (C) to Seat (A) with Flat Washers, Spring Washers and Head Cap Bolts,
tightening bolts only halfway.
(See Figure 1)
Attach Front Stretcher (G) to unit with Wood Screws.
(See Figure 2)
E
Orientate Side Stretchers (E) and (F) so Arrow labels are at front of unit, then attach
Side Stretcher (E) to Leg (B) and Side Stretcher (F) to Leg (C) with Wood Screws.
Figure 1
Figure 2
Page 3
Assembly Instructions 3/3
Head Cap Bolt (long)
Spring Washer
Flat Washer
Head Cap Bolt (short)
Spring Washer
Flat Washer
Wood Screw
D
STEP 2
Attach Back Frame (D) to unit with Flat Washers,
Spring Washers, Head Cap Bolt (short), Head Cap Bolts (long),
tightening bolts only halfway.
(See Figures 3 and 4)
Tighten all Head Cap Bolts used in Steps 1 and 2.
Attach Back Frame (D) to unit with Wood Screws.
Figure 3
Figure 4
Page 4
CARE INSTRUCTIONS
NEVER
allow liquids to remain on furniture.
Absorption causes parts to warp
and split and finishes to delaminate.
Do not use power tools
above 8 volts to assemble.
PREVENT
CRACKING
Do not place
in direct sunlight.
PREVENT
FADING
NEVER
use glass cleaners on
finished furniture. Ammonia
chemically attacks the finish.
Do not write
directly on surface.
PREVENT
MARKING
Do not place hot
objects on surface.
PREVENT
FINISH DAMAGE
Do not use rubber
based placemats.
PREVENT
DISCOLORING
CLEAN
with a soft cloth moistened
in lukewarm soap and water.
Buff with a dry clean cloth.
Do not use commercial
waxes and polishes.
PREVENT
YELLOWING
Loading...