Page 1
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.2)
1. Return the arms to suitable position.
2. Attach the loop(A) to the top pipe thread of the fixture body(B),lock it until tighten.
3. Raise the candle sleeve(C) insert the lamp holder.
4. Install the light bulbs(not included) in accordance with the fixture’s specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
** If you not need assembly the fixture loop,
** Please pause and refer to Fig. 2.1.
1. Take out the bottom loop of the canopy and take the loop of lamp body , then take the
canopy to the lamp body, lock it with the lock washer and hex nut until tight.
2. Attach the lamp body to the ceiling, lock it securely with the ball nuts.
HANGING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove old fixture from ceiling, including
the old single bar. Carefully unpack new fixture and lay all the parts on a clear surface.
2. Attach the mounting screw part way into the side hole of the single bar, then lock it
securely with hex nut until becoming. Attach the single bar to the junction box using
two box screws as shown. The side of the single bar marked “GND” must face out.
3. Using proper chain pliers to open one end link of the chain provided and connect to the
fixture loop. Close the link.
4. By measuring, determine correct number of links needed for proper hanging height.
Using proper chain pliers disconnect and discard remaining chain.
5. Lace the fixture wires through the chain.
6. Open the other end link of the chain and hang the fixture on the loop at the ceiling.
Close the link.
7. Feed the fixture wires through the loop of the canopy and pull until taut.
8. Slide canopy up flush to ceiling, lock it securely with ball nut.
CONNECTING THE WIRES (Fig.3)
1. Take the black wire from the ceiling junction box and the smooth wire leg from the
fixture and twist bare ends together. Twist wire connector onto end of wire until snug.
2. Repeat same process with white junction box wire and ribbed wire leg of fixture wire.
NOTE: Twist wires together in the same direction you twist the wire connector onto
wires.
3. If your junction box has a grounding wire (green or bare copper), attach this wire and
the bare copper wire from the fixture together as step 1.If junction box has no ground
wire, attach the bare copper fixture wire to the green ground screw on the single bar.
4. Tuck these wire connections neatly into the ceiling outlet box and then raise the
canopy all the way to the ceiling, lock it securely with ball nuts.
Your installation is now complete. Return power to the junction box and
test the fixture.
installation instructions do apply to this product.
Fig.2
single bar
FIG.3
Screw
FIXTURE
WIRES
Black or
Smooth
Fig.2.1
Hex
Nut
HOUSE
WIRES
Black(Hot)
A
B
C
B
C
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIG.1
Screw
single bar
FIXTURE
WIRES
Bare
Copper
(Ground)
Green or Bare
Copper(Ground)
HOUSE
WIRES
Loading...