Page 1
FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING
ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.
GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the
order given. Under no circumstances should a fixture be hung on house electrical wires, nor
should a swag type fixture be installed on a ceiling which contains a radiant type heating system.
Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician.
NOTE: Proper wiring is essential for the safe operation of this fixture.
ASSEMBLY INSTRUCTIONS
585PHMR-LED & 585PHMS-LED & 585PHBR-LED & 585PHBS-LED
POST FITTER SCREW
GROUND WIRE
WIRE CONNECTOR
POWER SUPPLY WIRE
MOUNTING POST
READ & SAVE
INSTALLATION & OPERATION INSTRUCTIONS
TOOLS & MATERIALS REQUIRED
Screwdriver Wire Cutters
Adjustable Wrench Wiring Supplies
CAUTION
Prior to assembly, refer to ELECTRICAL CONNECTIONS section. If you do not have
electrical wiring experience, refer to a do-it-yourself wiring handbook or have your
fixture installed by a qualified licensed electrician.
GENERAL
Page 2
1. Be sure to read these instructions and review the diagrams thoroughly before
beginning.
2. Electrical connections must be in accordance with local codes, ordinances, or the
National Electric Code. If you are unfamiliar with methods of installing electrical wiring,
secure the services of a qualified licensed electrician.
3. Before starting the installation, disconnect the power by turning off the circuit
breaker or by removing appropriate fuse at fuse box. Turning the power off at the light
switch is not sufficient to prevent electrical shock.
PREPARE THE FIXTURE
NOTE: First turn off electricity
FINAL ASSEMBLY
1. Pull the black, white and ground wires out of mounting post.
2. While supporting the fixture, connect electrical wires. If your post has a ground wire
(green or bare copper), connect the fixture ground wire to it. If not, consult your
electrician for proper grounding.
ELECTRICAL CONNECTIONS 120V~, 60Hz
Connect white wire(s) from fixture to white neutral wire from supply circuit.
Connect black wire(s) to black hot wire from supply circuit. Connect green wire to
green or bare wire or grounding screw on mounting bracket. In all cases grounding
conductor to earth must be used. Use UL/CSA Listed wire connects suitable for the
size, type, and number of conductors. No loose strands or loose wires should be
present. Secure wire connectors with UL/CSA Listed electrical tape.
After wires are connected, tuck them carefully inside the post cup.
3. Align the lantern with mounting post and secure with screws
4. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn
the light switch on to activate the fixture.
5. LED replacement. Take down the screw(1) and glass(2), unscrew the screws(3),
then pull out LED module, finally replace LED module by quick connector(4), secure
the screws.
CAUTION: LED fixtures can operate at high temperatures
please use caution when touching during operation or after
operation.
Page 3
Anchor Bolts
1-1/2" (38mm)
CEMENT BASE
Mounting Bracket
(set in and aligned with
top of concrete)
FIG.2
18" X 18"
(46 X 46cm)
Hex
Nut
(4)
Anchor
Bolt (4)
Mounting
Bracket
FIG.1
Cap Nuts (4)
Post Base
Pole 1
Pole 2
Pole 3
Please observe local building/electrical
codes regarding the installation of your
post fixture.Please keep in mind your
geographic location and the depth that
the ground freezes to,when deciding
the depth of your installation.
It is recommended to
use single fixture with
this post (not multiple
fixture units).
FIG.3
Loading...