Page 1
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJ ON CTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove old fixture,
2. Carefully unpack your new fixture and lay out all the parts on a clear
3. NOTE: Discharge the finial(A) and cover(B) of the lamp body(C).
4. Attach the candle sleeve(D) over the lamp holder.
5. Install the light bulbs (No Included) in accordance with the fixture's
6. Raise the cover(B) to the top pipe thread of lamp body(C), aligning
7. Attach the assembly lamp body onto the post (no included) and lock
CONNECTING THE WIRES (Fig.2)
1. Connect the electrical wires as follows. Connect the Black wire from
the fixture to the black house (hot) Wire. Connect the white wire from
the fixture to the white (neutral) house wire. Make sure all wire nuts
are secured. You may wrap the connections with electrical tape. If
your outlet box has a ground wires (green or bare copper) connect
fixture’s ground wire to it. Otherwise attach the bare copper fixture
wire to the green ground screw on the mounting plate.
2. Tuck the wire connections neatly into the post.
Your installation is now complete. Return power to the junction
box and test the fixture.
including the single bar.
area. Take care not to lose any small parts necessary for installation.
specifications. DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!
the top center hole with the pipe thread, then lock it securely with the
finial(A).
it securely with the screw(E).
FIG.1
FIG.2
Need assistance with parts or assembly? Please call customer service
©COYRIGHT ALL RIGHTS RESERVED.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
Thank you for purchasing our product.
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or Bare
Copper(Ground)
Loading...