Page 1
INSTALLATION INSTRUCTIONS FOR FIXTURE
MOUNTING THE FIXTURE (FIG. 1)
or bare copper), connect the fixture’s ground wire to it.
xture’s ground wire directly to
over
Fig.2
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
1. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture from wall including
the mounting hardware.
2. Carefully remove the new fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Attach the mounting plate (I) to the outlet box using
the outlet box screws
plate marked “GND” must face out.
CONNECTING THE WIRES (FIG. 2)
1. At this point, connect the electrical wires as shown
in Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green
Otherwise, connect the fi
the mounting strap using the green screw provided.
2. Tuck the wire connections neatly into the wall outlet
box.
MOUNTING THE FIXTURE (FIG. 1)
3. Attach the fixture wall plate over the mounting plate (I)
by protruding the mounting screws through the
mounting holes on the wall plate and securing with
ball nut (H) until snug.
4. Place the large glass shade (F), round ring (E), small
glass shade (D) and cushion ring (C) in this order
the socket (G). Then secure with socket ring (B) using
socket ring tool (A).
5. Install the bulb in accordance with fixture’s
specifications.
(J)
. The side of the mounting
(DO NOT EXCEED THE
----Mounting Plate
Mounting Plate
Mounting PlateMounting Plate
----Ground screw
Ground screw
Ground screwGround screw
----Mounting screws (2)
Mounting screws (2)
Mounting screws (2)Mounting screws (2)
Fig.1
SOCKET RING #SKT-RING-26
MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
Your installation is now complete. Return power to the
juction box and test the fixture.
Loading...