Mercury Row MCRW5030 Installation & Assembly

Label Picture Description QTY

A

Left Armrest 1

B

Back 1

C

Seat 1

D

Side Plate 1

E

Foot 4

F

Seat Cushion 1

G

Back Cushion 1

Caution: You must read this before you proceed

LEFT ARMREST

1 OF 6

Label Picture Description QTY

①

Allen Key (M6) 1

②

Bolt (M6*40mm) 13

③

Washer 13

④

Allen Key (M4) 1

⑤

Bolt (M6*45mm) 9

⑥

Washer Ring 9

Before Beginning Assembly:

2 OF 6

This Left Armchair has multiple parts and may require up to 30 minutes to assemble. To
give you an overview of the Left Armchair parts, the above picture is to help you put the
various parts into perspective. Please read through the instructions below to familiarise
yourself with the parts and steps before assembly.

Open the carton and place all the parts onto a clean, non-marring surface.
Place the Left Armrest(A) with its inside facing up.
Attach Back(B) to Left Amrest(A) using Bolt(②) and Washer(③) with Allen Key(①) as
shown above.

Do not fully tigthen.
ATTENTION: There may be some PE wicker that may have covered the Mounting
Points. To ease assembly, guide and slide the PE wicker away from these
Mounting Points.
DO NOT CUT AWAY ANY PE WICKER as this would cause the wicker to unravel!

Step 1

FRONT FACING

Left Armrest (A)

Seat (C)

Side Plate (D)

Back Cushion (F)

Back (B)

Seat Cushion

Foot (E)

3 OF 6

Step 3

Attach Side Plate(D) between the Back(B) and Seat(C) using Bolt(②) and Washer(③)
with Allen Key(①) as shown above.

Do not fully tigthen.

Attach Seat(C) between the Left Armrest(A) and Back(B) using Bolt(②) and Washer(③)
with Allen Key(①) from position # I to # V as shown above.

Do not fully tigthen.

Step 2

Step 4

Attach the Feet(E) to the Chair using Bolts(⑤) and Washer Rings(⑥) with Allen
Key(④).

4 OF 6

Place the Back Cushion(G)and Seat Cushion(F) onto the Left Armchair as shown.
Your Left Armchair is ready for use.
Caution:This Left Armrest can only be used on a flat, level surface.

Step 6

Turn the Left Armrest right side up.
Place the Left Armrest on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, sit into to the Left Armrest.
This would help to align all the parts at all the joint areas.
Then get off the Left Armrest, and in a sequential manner, proceed to tighten all bolts.

When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there is still wobbles, loosen the bolts and execute this same process.
If the Left Armrest is not stable it could lead to damage to the product.

Note: This step is done better with the assistance of a second adult.

Step 5

5 OF 6

6 OF 6