Page 1
ASSEMBLY INSTRUCTION
METAL SUPPORTS X-FRAME END TABLE
A
E
I
Top Panel
1PC
Screw
1/4”X1”XØ16
4PCS
Nut
3/16"
Lower Panel
B
1PC
Allen Wrench
F
1/4"
1PC
Spanner Wrench
J
3/16"
Side Frame
C
2PCS
Wood Screw
G
4*39 mm
4PCS
Phillip Screwdriver
K
I
(Not provided)
Tension Bar
D
2PCS
Machine Screw
H
3/16"X1/2"
5PCS
1PC
1PC
1PC
This page lists all the contents included in the box.
Please take the time to identify the hardware as
well as the individual components to this product.
As you unpack and prepare for assembly, place
the contents on a carpeted or padded area to
protect them from damage.
1
Page 2
***
Do not tighten screws & bolts until the entire unit is completely assembled.
Attach Tension Bar (D) to Side Frame (C) using Machine Screw (H) and Phillip Screwdriver (K). Then
1
secure middle using Machine Screw (H) and Nut (I). While holding Nut (I) with Spanner Wrench (J),
but not tighten it.
J
K
Attach Side Frame (C) to Top Panel (A) using Screw (E) and Allen Wrench (F) as shown. Attach Side
2
Frame (C) to Lower Panel (B) using Wood Screw (G) and a Phillip Screwdriver (K) as shown. Tight all
screws and carefully turn the assembled unit upright.
I
K
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry
or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all
connections are tight.
2
Loading...