Page 1
Product Dimensions: 23.6"W*25.2"D*31.1~34.1"H
PIECE QUANTITY
(1) 1X
(2)
1X
(3)
1X
(4)
1X
(5)
1X
(6)
5X
(7)
4X
(8)
4X
(9)
1X
Screw
Caster
Washer
Allen Wrench
Control Mechanism
Cylinder Column
Bellows
CARE AND MAINTENANCE
Wipe clean with a soft, dry cloth. The seat board can be cleaned with a mild cleaner. Test the
cleaning method on a hidden area before using them over the entire area .
NOTICE
* Please make sure that you have all parts indicated before you begin assembly of this item
* This item should be assembled on a soft surface to prevent scratching the finish during
assembly
* This item may require periodic tightening
Part List and Hardware List
DESCRIPTION
PICTURE
Star Base
Back Cushion+Seat Cushion
Page 2
Step 1 Step 2 Step 3
Step 4
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware
contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Tools Required for Assembly (included): Allen Wrench
The chair is ok now.
ATTENTION: MAKE SURE ALL SCREWS ARE
FULLY TIGHTENED BEFORE USING CHAIR
Attach Control Mechanism (2) to Seat Assembly (1) with the
arrow towards the front of the chair, using four Washers (8) and
four Screws(7).
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH
Now insert the small end of Cylinder Column (3)
into Control Mechanism (2) and carefully press
downward with moderate force until it is fully
seated.
Insert five Casters (6) into Star Base (5), push hard
until you feel or hear the Caster(6) snap into place.
Insert the LARGE end of Cylinder Column (3) with
the bellow(4) into the Star Base (5) and carefully
press downward with moderate force until it is fully
seated.
Loading...