Mercury 450.007UK, 16 Inch Copper Tripod Stand Fan User Manual

www.avsl.com 450.007UK User Manual

16 Inch Chrome Pedestal Fan

Order ref: 450.007UK

User Manual

A stylish, height-adjustable pedestal fan with 3 speed settings, oscillating head and tilt control. Ideal for home and work,
it is quiet yet powerful and offers flexible height, directional adjustment and an attractive chrome finish. The steel mesh
guard is easy to detach and replace, allowing for easy cleaning of the interior and fan blades as required.

Specification:

Cable length 1.6m
Power output 50W
Blade diameter 400mm
Mains power 220-240V
Height adjustment 970mm to 1230mm
Dimensions 1230 x 450 x 400mm
Weight 6.4 kg

Features:

• Quiet yet powerful 50W motor

• 3 speed settings

• Attractive chrome finish

• Versatile height, swivel and tilt adjustments

• Weighted circular base for extra stability

Assembly diagram:

1. Front grille

2. Fan blade

3. Fan blade screw

4. Rear grille fixing screws

5. Rear grille

6. Motor shaft

7. Speed control

8. Fan motor

9. Mains lead

10. Tilt adjustment screw

11. Inner tube

12. Height adjustment screw

13. Telescopic stand

14. Fan base

15. Base weight

16. Clamping washer

17. L-shaped lock screw

Assembling the base (see Fig. 1):

1. Unscrew the L-shaped locking screw (17) and remove it from the base (14) along with the clamping washer (16).

2. Now place the base weight (15) in the centre of the underside of the fan base (14) and the clamping washer (16)

into the centre of the base weight.

www.avsl.com 450.007UK User Manual

3. Next push the L-shaped lock screw (17) through the assembly and into the thread at the bottom of the telescopic

stand (13). Tighten firmly, but do not overtighten.

4. Loosen the height adjustment screw (12) and pull the inner tube out from the telescopic stand to the desired

height, then retighten the screw.

Attaching the motor housing to the stand base (see Fig. 2):

1. First remove the pivot screw (7) and the bolt (20) from the top of the telescopic stand, then remove the neck

retaining screw (8) and small adjustment screw (19) from the motor housing bracket.

2. Place the motor housing on the top of the stand and thread the large pivot bolt (20) through the bracket. Screw in

the small retaining screw (8) and tighten, but do not overtighten.

3. Fit the large pivot screw (7) onto the end of the bolt (20) and the small adjustment screw (19) at the other side

above the bolt. Tighten the screws while holding the fan motor upright.

Assembling the fan blade and grilles (see Fig. 3):