Merco Savory ST-1 User Manual
INSTALLATION & OPERATION MANUAL for ST-1
Mini-Conveyor Toaster
The ST-1 “Mini-Toaster” is capable of
one or two-sided toasting of a variety
of bread products such as: Breads,
buns, bagels, English muffins and
raisin bread.
The ST-1 is a horizontal conveyor
toaster that has high production
capabilities, yet is scaled down in size
to accommodate operations with a
minimum of counter space.
The ST-1 is available in 120V, 208V,
220V and 240V models. All models are
equipped with variable conveyor
speed, and an energy saver switch
standard.
BEFORE INSTALLATION
NOTE: Upon receipt of this unit, immediately unpack and inspect for possible concealed
shipping damage. If unit is found to be damaged, save all packing materials and contact your
delivery carrier within 5 days. Refer to “Shipping Damage Instructions” enclosed for detailed
instructions. Failure to follow these instructions will negate Merco/Savory’s or your ability to
file claims and receive compensation for shipping damage.
This manual contains important safety and installation-operations instructions. Require all operators to read this
manual before using the unit. Failure to follow the instructions contained in this manual may cause injury, damage to the unit, and will void the warranty.
THIS MANUAL SHOULD BE RETAINED FOR FUTURE USE
0201-JDM 07023
INSTALLATION INSTRUCTIONS
Install the ST-1 in the most convenient location for ease of cleaning, maintenance and general operation. Avoid installing in
locations with drafts, close proximity to grease or vapor-producing appliances or other high ambient heat equipment. Allow
approximately 1” clearance on sides and back of unit for proper air circulation. Allow sufficient overhead clearance for
proper heat dissipation. This toaster must be level for proper operation and comes equipped with 1” adjustable legs for this
purpose. See instruction sheet enclosed for details.
Before operating this unit, be sure that the following two components are properly installed:
1. The reflector tray is installed below the lower heating elements before shipping. It merely slides under the conveyor.
NOTE: Proper toasting cannot be performed without reflector tray installed.
2. The toast receiving tray is packaged separately and must be installed before operating this unit. For front delivery
position, slide the receiving tray into the toaster cavity below the control panel, making sure the lipped end is towards
the back. Place the lipped end over the 2 protruding pins located at the rear of the toaster cavity. For rear delivery
position, slide the receiving tray into the cavity from the back of the toaster and place the lipped end over the 2 protruding pins located closest to the front of the toaster. (See Figure 1)
WARNING
This toaster must be plugged
Into the proper voltage which is
Specified on the data plate
Located on the back panel of
The toaster. Use of any other
Voltage or altering of plug
Will damage unit, void
Warranty and may cause
Injury.
ELECTRICAL SPECIFICATIONS
The circuit on which the receptacle is installed must be of adequate wiring size and sufficient capacity to meet the
requirements indicated on the unit data plate and in accordance with the National Electrical Code and local
electrical installation codes. *The 220V electrical information in the shaded area pertains to European models.
The 240V electrical information in the shaded area pertains to United Kingdom models.
2
Loading...