Merco SW, SW-34 Installation Manual
INSTALLATION & OPERATION MANUAL for SW Series
Food Warmers
The SW Series Food Warmers are
available in three models (SW-18,
SW-22 and SW-34). Each is designed to accompany a corresponding SG Series Hot Dog Grill,
but may be used independently.
These versatile Food Warmers may
be operated wet or dry. Product
may be kept in its original packaging or placed directly into drawer.
Some experimentation will help
determine which type of operation
is best suited for your specific
needs.
The instructions contained in this
manual apply to all models in the
SW Series.
SW series ‘BUN warmer” shown with
SG Series “Hot Dog Grill” SG-24S
NOTE: Upon receipt of this unit, immediately unpack and inspect for possible concealed
shipping damage. If unit is found to be damaged, save all packing materials and contact your
delivery carrier within 5 days. Refer to “Shipping Damage Instructions” enclosed for detailed
instructions. Failure to follow these instructions will negate Merco/Savory’’ or your ability to
file claims and receive compensation for shipping damage.
This manual contains important safety and installation-operation instructions. Require all operators to read this
manual before using the unit. Failure to follow the instructions contained in this manual may cause injury, damage to the unit, and will void the warranty.
THIS MANUAL SHOULD BE RETAINED FOR FUTURE USE
0201-JDM 07022
INSTALLATION INSTRUCTIONS
Place SW Series Food Warmers in the most convenient location for ease of cleaning, maintenance, service and general
operation. When installing this unit, avoid drafts, close proximity to grease, vapor-producing appliances or other high
ambient heat equipment.
A minimum of 1” clearance on top, both sides and bottom is required for proper air circulation. This clearance is assured by
the 1” adjustable legs supplied with the unit.
WARNING
This unit must be used with the proper voltage as
Specified on the unit data plate located on rear
Panel. Use of any other voltage or altering plug
Will damage unit, void warranty
And may cause injury.
The circuit on which the receptacle is installed must be of adequate wiring size and sufficient to meet the requirements
indicated on the unit data plate and in accordance with the National Electrical Code and local electrical installation codes.
Failure to meet these requirements will void the warranty.
Before connecting this unit to a power source, remove all packing materials.
**Models shipped overseas are supplied with power cord only.
2
Loading...