INSTALLATION & OPERATING
INSTRUCTIONS
for
PIZZA DISPENSING CABINET
PDC2 Series & PDC3 Series
THIS MANUAL CONTAINS IMPORTANT SAFETY AND INSTALLATION-OPERATION INSTRUCTIONS. REQUIRE ALL
OPERATORS TO READ THIS MANUAL BEFORE USING THE UNIT. FAILURE TO FOLLOW THE INSTRUCTIONS
CONTAINED IN THIS MANUAL MAY CAUSE INJURY AND/OR DAMAGE TO THE UNIT AND WILL VOID THE WARRANTY.
!
PDC2 Series PDC3 Series
THIS MANUAL SHOULD BE RETAINED FOR FUTURE USE
PDC2and3ops REV: 8/8/07
SITE PREPARATION AND USE
Place the Pizza Dispensing Cabinet on a table or counter capable of supporting the weight of 1000 lbs. The power
supply must be in accordance to the specifications on the data plate located on the rear of the appliance. This unit is
designed to hold boxed pizzas at proper temperatures and manufactured for even heat transfer and easy cleaning.
DIMENSIONS AND SPECIFICATIONS
(inches/cm)
PDC3 SHOWN BELOW
ITEM NO. MODEL NO. “A” “B” “C” VOLTAGE AMPS WATTS CORD/PLUG
PDC2-2123-M 436510 21-5/8” 30-7/8” 1” 120 VAC 8.3 995 NEMA 5-15P
PDC3-2123-M 436570 21-5/8” 39” 1” 120 VAC 12.4 1485 NEMA 5-15P
PDC2-2723-M 436540 27-5/8” 30-7/8” 1” 120 VAC 9.9 1187 NEMA 5-15P
PDC3-2723-M 436580 27-5/8” 42” 4” 120 VAC 14.8 1772 NEMA 5-20P
PDC2-3623-M 436560 36-5/8” 30-7/8” 1” 120 VAC 13.3 1597 NEMA 5-20P
PDC3-3623-M 436590 36-5/8” 42” 4” 120 VAC 19.9 2387 NEMA 5-30P
PDC-2 & PDC-3 Series Operations Manual
2
WARNING
:
OPERATION
NOTE: The holding temperature for the Merco Pizza Dispensing Cabinet is factory pre-set for optimum holding time.
No adjustment for temperature is required.
1. Insure unit is plugged into proper power supply.
2. Turn power to the “ON” position. (There are separate switches for each level. Lights and heat are controlled
by these switches.)
3. Allow for a 20-minute preheat.
CLEANING
NOTE: The following cleaning instructions must be carried out to ensure satisfactory performance of your Pizza
Dispensing Cabinet. Neglecting to follow these procedures may result in reduced reliability and void the
warranty.
!
DAILY CLEANING
1. Wipe down entire unit with a clean soft cloth and warm soapy water to remove any remaining food product.
WEEKLY CLEANING
1. Remove the glass sides by lifting straight up and pulling out, using the lifting tabs on the glass frame bottom.
Use appropriate glass cleaner.
2. Wash all levels with a soft cloth or sponge dampened with warm soapy water.
NOTE: Do not flood the unit with cleaning liquid.
3. Rinse using a cloth dampened with clear water, then dry.
4. Install glass sides.
ALLOW THE PIZZA DISPENSING CABINET TO COOL SUFFICIENTLY TO THE
TOUCH BEFORE ATTEMPTING ANY CLEANING PROCEDURES.
PDC-2 & PDC-3 Series Operations Manual
3
BULB REPLACEMENTS
FLUORESCENT LAMP
!
WARNING:
DO NOT EXCEED BULB WATTAGE RATINGS OR SPECIFICATIONS.
1. Remove the plexiglass front cover and the opaque plastic panel by sliding it sideways out of the holding
channels.
2. Replace with fluorescent bulb using a GEF15T12CW or equivalent. This is a 15-watt, 17-inch cool white bulb.
3. Install plexiglass covers.
INCANDESCENT BULBS
1. Replace burnt out bulbs only with 40-watt coated Appliance Lamps.
NOTE: These lamps are Teflon coated. Replacement lamps must be coated for NSF approval.
SERVICE
If the unit fails to operate, check the circuit breaker to be sure it is turned on and check the “ON/OFF” switches to be
sure they are turned on before you call a service agency. To find the service agency nearest you, call the Technical
Service Hotline at (800) 678-9511 or visit our website at www.mercosavory.com.
PARTS
Part Number Description Part Number Description
000170 Bushing, Heyco, SR-7K-2, #1240 436324 Cover, Box, Switches
000370 Lamp, 130V, 40W, Frost, Coat, 40A 15 436340 Plexiglass, Opaque
000466 Wirenut, Ceramic, Hi-7 436341 Plexiglass, Clear
000470 Wirenut, Thermosplastic 436347 Label, Caution Hot, Red Lettering
000535 Plug, ¾”, Round, Nickel 436348 Label, Switches
000695 Label, Caution Hot 436350 Cover, Thermocable
000749 Thermostat, Bilbee #A 1200 436351 Sign Holder
111851 Thermocable, 120V, 330W 112174 Glass Assy, Left, 2-Tier, (from switches side)
12688 Leg, Plastic, 1” 112175 Glass Assy, Right, 2-Tier, (from switches side)
369537 Power Cord w/ Plug 112176 Glass Assy, Left, 3-Tier, (from switches side)
369805 Switch, Rocker, Lighted 112177 Glass Assy, Right, 3-Tier (from switches side)
436319 Track, Glass 69523 Bushing, Heyco, LTF-R11, #8876, UL
436320 Brace, Cross 69524 Nut, Lock, Heyco Bushing, GMP11
112178 Rear Hinged Door
112179 Front Glass Panel
PDC-2 & PDC-3 Series Operations Manual
4
LIMITED WARRANTY FOR COMMERCIAL PRODUCTS
LIMITED WARRANTY
Merco/Savory LLC, ("Merco”) warrants this product to be free from defects in material and workmanship for a period of:
• One (1) year from the date the product is installed or eighteen (18) months from the date of shipment from our facility, whichever comes first.
• Heating elements only – two (2) year warranty against burnout (excluding breakage) from date of shipment from our facility.
• Hot Food Server products only – one (1) year labor, two (2) years parts from the date of shipment from our facility.
During the warranty period, Merco shall, at Merco’s option, repair, or replace parts determined by Merco to be defective in material or workmanship,
and with respect to services, shall re-perform any defective portion of said services. The foregoing shall be the sole obligation of Merco under this
Limited Warranty with respect to the equipment, products, and services. With respect to equipment, materials, parts and accessories manufactured
by others, Merco’s sole obligation shall be to use reasonable efforts to obtain the full benefit of the manufacturer’s warranties. Merco shall have no
liability, whether in contract, tort, negligence, or otherwise, with respect to non-Merco manufactured products.
WHO IS COVERED
This Limited Warranty is available only to the original purchaser of the product and is not transferable.
EXCLUSIONS FROM COVERAGE
• Repair or replacement of parts required because of misuse, improper care or storage, negligence, alteration, accident, use of incompatible
supplies or lack of specified maintenance shall be excluded
• Normal maintenance items, including but not limited to, light bulbs, fuses, gaskets, O-rings, interior and exterior finishes, lubrication, de-liming,
broken glass, etc.
• Failures caused by improper or erratic voltages
• Improper or unauthorized repair
• Changes in adjustment and calibration after ninety (90) days from equipment installation date
• This Limited Warranty will not apply to any parts subject to damage beyond the control of Merco, or to equipment which has been subject to
alteration, misuse or improper installation, accidents, damage in shipment, fire, floods, power changes, other hazards or acts of God that are
beyond the control of Merco.
• This Limited Warranty does not apply, and shall not cover any products or equipment manufactured or sold by Merco when such products or
commercial equipment is installed or used in a residential or non-commercial application. Installations not within the applicable building or fire
codes render this Limited Warranty and any responsibility or obligations associated therein null and void. This includes any damage, costs, or
legal actions resulting from the installation of any Merco commercial cooking equipment in a non-commercial application or installation, where
the equipment is being used for applications other than those approved for by Merco.
LIMITATIONS OF LIABILITY
The preceding paragraphs set forth the exclusive remedy for all claims based on failure of, or defect in, products or services sold hereunder,
whether the failure or defect arises before or during the warranty period, and whether a claim, however instituted, is based on contract, indemnity,
warranty, tort (including negligence), strict liability, implied by statute, common-law or otherwise , and Merco its servants and agents shall not be
liable for any claims for personal injuries, incidental or consequential damages or loss, howsoever caused. Upon the expiration of the warranty
period, all such liability shall terminate. THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES,
WHETHER WRITTEN, ORAL, IMPLIED OR STATUTORY. NO IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR PARTICULAR
PURPOSE SHALL APPLY. MERCO DOES NOT WARRANT ANY PRODUCTS OR SERVICES OF OTHERS.
REMEDIES
The liability of Merco for breach of any warranty obligation hereunder is limited to: (i) the repair or replacement of the equipment on which the liability
is based, or with respect to services, re-performance of the services; or (ii) at Merco’s option, the refund of the amount paid for said equipment or
services.
Any breach by Merco with respect to any item or unit of equipment or services shall be deemed a breach with respect to that item or unit or service
only
WARRANTY CLAIM PROCEDURE
Customer shall be responsible to:
• Immediately advise the Dealer or Merco’s Authorized Service Agent of the equipment serial number and the nature of the problem.
• Verify the problem is a factory responsibility. Improper installation or misuse of equipment, are not covered under this Limited Warranty.
• Cooperate with the Service Agency so that warranty service may be completed during normal working hours.
• Travel Time not to exceed two hours and mileage not to exceed one hundred (100) miles.
• Portable equipment weighting less than ninety (90) pounds must be delivered to the Service Agent at Customer’s expense.
GOVERNING LAW
This Limited Warranty shall be governed by the laws of the state of Delaware, USA, excluding their conflicts of law principles. The United Nations
Convention on Contracts for the International Sale of Goods is hereby excluded in its entirety from application to this Limited Warranty
Merco Savory LLC
1111 North Hadley Road
Fort Wayne, Indiana 46804
USA
www.mercosavory.com
PDC-2 & PDC-3 Series Operations Manual
5
PDC-2 & PDC-3 Series Operations Manual
6
This page intentionally left blank.
PDC-2 & PDC-3 Series Operations Manual
7
Merco Savory, LLC
1111 North Hadley Road
Fort Wayne, Indiana 46804
United States of America
Telephone: (260) 459-8200
U.S. Fax: (888) 790-8193
Int’l Fax: (260) 436-0735
Service Hotline: (800) 678-9511
www.mercosavory.com
PDC-2 & PDC-3 Series Operations Manual
8
Loading...